Page 1
IDS product guide Dual beam Introduction This is a guide to illustrate how to install a single pair of IDS Dual Beams. 1. Beam installation 1.1. Mounting beam Remove the cover. Attach the paper stencil onto the location where the beam is to be mounted and drill the holes in the marked positions.
Page 2
1.2. Beam alignment On both the transmitter and receiver look through the view finder at a distance of 5cm, and adjust the vertical and horizontal angles until the opposite beam is in the centre of the view finder. You can adjust the horizontal angle using the Horizontal angle adjustment knob, and the vertical angle using the Vertical angle adjustment screw.