• WARNING: To ensure the safety of the equipment as well equipment should determine compatibility of the materials the individuals using them, only use Spraying Systems Co. used and any of the potential hazards involved. components.
INTRODUCTION The TankJet 78 and 78D models are hydraulically driven removed from service and cleaned out-of-place (COP) to ® rotating heads with nozzles ejecting streams of liquid for remove any debris or other solids that may have collected internal tank surfaces, cleaning, sanitizing, treating, or during operation.
INSTALLATION The TankJet 78 is easy to install. Both the TankJet 78 and Slip the supply tube into the inlet of the unit, aligning the ® 78D connect to a supply tube with a simple retaining clip. holes. Insert the retaining clip and swing it down until it There are two different size options for inlet connections to locks.
This warranty includes manufacturing defects but does not cover wear of components. This warranty will be void if parts other than those supplied by Spraying Systems Co. are used or if the unit is modified by anyone other authorized Spraying Systems Co.
When the device requires replacement parts, only 4. Slide the hub cap bearing (20) onto the hub cap (21). Spraying Systems Co. components should be used, in Note the direction of the bearing is critical and will not order to maintain proper machine operation and safety.
Need help?
Do you have a question about the TJ78-375-3A Series and is the answer not in the manual?
Questions and answers