Page 1
TPM8PLATE Ceiling Mount Tray Assembly Instructions WARNING: A QUALIFIED PROFESSIONAL SHOULD BE USED TO PROPERLY INSTALL THIS UNIT TO THE CEILING. BRETFORD WILL NOT BE LIABLE FOR THE IMPROPER USE OR INSTALLATION OF ITS PRODUCTS. PARTS LIST HARDWARE LIST Ref.
Page 2
CEILING TRACK CEILING TRACK STEP 2 Position the assembled ceiling tray onto your ceiling track. The installation of electrical boxes should be done by a qualified electrician. NOTE: For clarity, only the ceiling track is shown. FULLY OPEN TURNBUCKLE STEP 3 Cut the 20-ft tie wire (CC) into four equal pieces.
Page 3
STEP 4 Anchor the tray assembly to the ceiling using the correct anchoring method listed below. NOTE: Position anchoring holes so that the tie wire, when attached and taut, will angle outward at 15°. (FF) (EE) 1. Drill four 1/4" diameter holes 1 3/8" Drill four 5/32"...
Page 4
5. Take up the slack in the safety cable, leaving it slightly loose and tighten both safety cable clamps. WARNING: THE LOAD MUST BE CARRIED BY THE TIE WIRES, NOT BY THE SUSPENDED CEILING TRACK. Bretford Bretford Ltd. 11000 Seymour Avenue Technology House Franklin Park, IL 60131 2 Etongate, 110 Windsor Road TEL: 847.678.2545...