Advertisement
Quick Links
INSTRUCTION MANUAL - GUIDE D'INSTALLATION
N003
TUB door - porte de BAIN
2 PEOPLE REQUIRED
2 PERSONNES REQUIS
IT IS MANDATORY TO HAVE A WALL STUD ON EACH SIDE OF
THE TUB UNIT TO SECURELY FASTEN THE RAIL TO THE WALLS.
IL
EST
OBLIGATOIRE
D'AVOIR
UNE
OSSATURE
MURALE
SUR
CHAQUE CÔTÉ DU BAIN POUR FIXER LA BARRE DE ROULEMENT.
Advertisement
Related Manuals for Fleurco N003
Summary of Contents for Fleurco N003
- Page 1 INSTRUCTION MANUAL - GUIDE D’INSTALLATION N003 TUB door - porte de BAIN 2 PEOPLE REQUIRED 2 PERSONNES REQUIS IT IS MANDATORY TO HAVE A WALL STUD ON EACH SIDE OF THE TUB UNIT TO SECURELY FASTEN THE RAIL TO THE WALLS.
-
Page 2: Instructions Générales
INSTRUCTION MANUAL - GUIDE D’INSTALLATION GENErAL INSTrUCTIoNS • read this manual carefully and completely before proceeding. • It is recommended that you wear safety glasses at all times during the installation. INSTALLATIoN oVEr CErAMIC TILES • If your tub door is to be installed over ceramic tiles, the tiles should lie completely under the wall jamb. •... - Page 3 INSTRUCTION MANUAL - GUIDE D’INSTALLATION TOOLS REQUIRED / OUTILS REQUIS LoNG NoSE LoCKING PLIErS SCrEWdrIVErS drILL pINCe Serre étau tourNevIS perCeuSe PENCIL 1/4" & 1/8" drILL BITS SILICoNE CraYoN MÈCHE 1/4˝ & 1/8" SCeLLaNt CUTTING PLIErS LEVEL TAPE MEASUrE pINCe CoupaNte NIveau ruBaN À...
- Page 4 INSTRUCTION MANUAL - GUIDE D’INSTALLATION PARTS LISTING / LISTE DES PIÈCES hArdWArE / quINCaILLerIe / ITEM PARTS- PIÈCES WALL JAMB / JamBage EXPANDER / exteNSeur EXPANDER GASKET / JoINt De L’exteNSeur FIXED PANEL “U” CHANNEL / proFILé “u” eN aLumINIum MIDGASKET / JoINt LatéraL DOOR SIDE GASKET / JoINt De porte BOTTOM DOOR GASKET/ JoINt INFérIeur De porte...
- Page 5 INSTRUCTION MANUAL - GUIDE D’INSTALLATION VvVV DOOR PANEL ASSEMBLY / ASSEMBLAGE DE LA PORTE COULISSANTE Use a mallet to install bottom gasket (7) on the bottom of the door panel (9). To facilitate installation place door panel on cardboard packaging box and use as platform.
- Page 6 INSTRUCTION MANUAL - GUIDE D’INSTALLATION WALL JAMB INSTALLATION / INSTALLATION DES JAMBAGES Place door panel (9) inside tub to simplify the following installation procedures. Place the panel on cushioned surface, such as a towel or carboard, to prevent damage either to the panel or the tub.
- Page 7 INSTRUCTION MANUAL - GUIDE D’INSTALLATION WALL JAMB INSTALLATION / INSTALLATION DES JAMBAGES Place wall jamb against wall using centerline previously marked as a guide. Be sure to center the slotted holes with the centerline. Level and mark locations of the four holes to be drilled.
- Page 8 INSTRUCTION MANUAL - GUIDE D’INSTALLATION WALL JAMB INSTALATION / INSATLLATION DES JAMBAGES / INSTALACIÓN DE PERFILES DE SUJECIÓN WALL JAMB INSTALLATION / INSTALLATION DES JAMBAGES Insert one drop of silicone in each hole in the wall before inserting the supplied wall plugs (4x) Add silicone to exterior bottom edge of wall jamb.
- Page 9 INSTRUCTION MANUAL - GUIDE D’INSTALLATION RUNNING RAIL / BARRE DE ROULEMENT Unfasten set screws from wall bracket (13). (x4) Then remove back plate from the wall braket and set aside. With back plates of wall brakets removed, slide the wall brackets away from the ends of the running rail (12).
- Page 10 INSTRUCTION MANUAL - GUIDE D’INSTALLATION 5 RUNNING RAIL / BARRE DE ROULEMENT Push wall brakets against wall. (x2) Trace outer side of wall braket. (x2) glisser les supports muraux jusqu’au mur. (x2) tracer le contour extérieur du support mural. (x2) INSIdE oF TUB INtérIeur Du BaIN...
- Page 11 INSTRUCTION MANUAL - GUIDE D’INSTALLATION 6 BOTTOM GUIDE / GUIDE INFÉRIEURE Trace edge of “U”-channel (4) to determine loca- tion of bottom guide. remove glass fasteners, running rail, brackets, fixed panel and “U”-channel (4). Put aside. Only the wall jamb (1) and previously assembled door panel should stay in place.
- Page 12 INSTRUCTION MANUAL - GUIDE D’INSTALLATION “U” - CHANNEL POSITIONING / EMPLACEMENT DU PROFILE EN ALUMINIUM “U” Remove protective film on pre-applied adhesive tape underneath “U” channel (4). Align “U”-channel with previsouly marked lines on base and press down to bond to base. Enlever le film protecteur du ruban adhésif préappli- qué...
- Page 13 INSTRUCTION MANUAL - GUIDE D’INSTALLATION INSTALLATION DES PIÈCES DE FINITIONS / FINISHING PARTS INSTALLATION / INSTALACIÓN DE COMPONENTES FIXED PANEL INSTALLATION / INSTALLATION DU PANNEAU FIXE Align bottom guide to edge of “U”-channel and center it with center of “U”-channel. INSIdE oF TUB once in place mark hole location.
- Page 14 INSTRUCTION MANUAL - GUIDE D’INSTALLATION RUNNING RAIL / BARRE DE ROULEMENT Install running rail. Align holes in rail with glass fasteners (14) level rail. Tighten glass fasteners with INSIdE oF TUB key to hold rail in place. (see step 5) INtérIeur Du BaIN Push wall brackets towards wall and lock in with back...
- Page 15 INSTRUCTION MANUAL - GUIDE D’INSTALLATION INSTALLATION DU PANNEAU DE PORTE / DOOR PANEL INSTALLATION / INSTALACIÓN DEL PANEL DE LA PUERTA WALL JAMB AND EXPANDER / JAMBAGE ET EXTENSEUR drill through wall jamb hole with 1/8" drill bit to pierce through the expander.
- Page 16 INSTRUCTION MANUAL - GUIDE D’INSTALLATION 13 DOOR GASKETS / JOINT DE PANNEAU DE PORTE Temporarily install midgasket (5) and door side gasket (6) to door panel. Close door entirely, mark interference of gaskets with running rail. Cut gasket at marked locations with cutters. Note that midgasket (5) needs only to be cut below running rail.
- Page 17 INSTRUCTION MANUAL - GUIDE D’INSTALLATION 14 ANTI-JUMP & DOOR STOPPER / ANTI-SAUT & BUTOIR Install anti-jump (16) in lower holes of door panel lo- cated below the running rail. Be sure to place gaskets between contact of glass and aluminium parts. (x2) Install door stopper (15) located in the interior of shower next to wall jamb.
- Page 18 INSTRUCTION MANUAL - GUIDE D’INSTALLATION DOOR RECEIVER INTALLATION / INSTALLATION RÉCEPTRICE DE PORTE Place door receiver (18) against wall, place so that the door panel slides smoothly into receiver. Mark hole location. drill in marked location with 1/8" drill bit. Use ce- ramic drill bit if drilling through ceramic tiles.
- Page 19 INSTRUCTION MANUAL - GUIDE D’INSTALLATION SEALING / CALFEUTRAGE Silicone the outside of the tub along the wall jamb and the exterior side of aluminum threshold and “U”-channel. Wait 24 hours before using the shower to allow silicon to dry. Calfeutrer avec du silicone l’extérieur de l’unité autour du jambage et à l’extérieur du seuil en aluminium et du profilé en aluminium. Attendre 24 heures avant de faire fonctionner la douche afin que le silicone sèche.