For melting and pumping non-explosive hot melt thermoplastic adhesives. hot melt tank. (50 pages)
Summary of Contents for Graco InvisiPac 25E605
Page 1
Installation ® InvisiPac Sift-Proof Nozzle Kits 3A7033B ™ For dispensing hot melt adhesive from an InvisiPac GS35 Plug-Free Applicator to create a sift-proof seal. For professional use only. See page 2 for kit information. Important Safety Instructions Read all warnings and instructions in this manual and in all related manuals before using the equipment.
Page 2
Parts ........4 Kits and Accessories ......4 Related Manuals These manuals are available at www.graco.com. Part Description ®...
Page 3
Installation Installation Installation Steps WARNING NOTE: The GS35 sift-proof module (Kit no. 25E616) is required for installing the sift-proof nozzle. 1. Follow the Pressure Relief Procedure. BURN HAZARD 2. Refer to the Module Repair Kit Instructions to install Kit 25E616. See Related Manuals on page 2. Equipment surfaces and fluid that is heated can become very hot during operation.
Page 4
Graco Information For more information about InvisiPac, visit www.InvisiPac.com or email InvisiPac@graco.com. TO PLACE AN ORDER, contact your Graco distributor or call to identify the nearest distributor. For technical assistance or customer service, call toll free: 1-800-458-2133. All written and visual data contained in this document reflects the latest product information available at the time of publication.