Download Print this page

Rompa HYDROFIT 19957 Quick Start Manual

Please read these instructions carefully BEFORE attempting to install/use this

product and then keep them in a safe place for future reference

IMPORTANT NOTE: If in doubt about the installation of this product, seek advice from a

suitably qualified electrician

CONTENTS

Your Hydrofit arrives in one box containing:

Hydrofit unit

Mattress

Hose

Please note: this product does not a RCD (residual current

device). We recommend the use of a RCD with a rated

breaking current of not more than 30mA is recommended

in the electric circuit of the bathroom. If in any doubt,

please consult a suitably qualified electrician.

HYDROFIT 19957

HYDROFIT 19957, KH 2.10

Table of Contents

Need help?

Do you have a question about the HYDROFIT 19957 and is the answer not in the manual?

Page 1 We recommend the use of a RCD with a rated breaking current of not more than 30mA is recommended in the electric circuit of the bathroom. If in any doubt, please consult a suitably qualified electrician. HYDROFIT 19957, KH 2.10...
Page 2 • Place a 3V CR2032 type battery into the Remote Controller. Turn the Remote Controller over so its back is uppermost. Use a coin to open the Remote Controller. Insert the battery and close by turning the coin again. HYDROFIT 19957, KH 2.10...
Page 3 Press POWER ON/OFF button in centre to start The Hydrofit will operate at the lowest intensity. SPEED Press the SPEED button to change the intensity to medium. Press the SPEED button again to obtain the most intensive level. HYDROFIT 19957, KH 2.10...
Page 4 Further copies of these instructions can be downloaded at www.rompa.com We hope you find our instructions invaluable. If you have any suggestions for improving them further your comments will be greatly received – please contact us at producthelp@rompa.com HYDROFIT 19957, KH 2.10...