Summary of Contents for SKUTCH AL-500P-II
- Page 1 INSTALLATION AND OPERATION MANUAL Please leave this manual with the unit after installation Important warranty information enclosed AL-500P-II 12/15/1999...
- Page 2 AL-500P-II 12/15/1999...
-
Page 3: Table Of Contents
Figure 1 – Rear Panel Connections Diagram.............5 Figure 2 – Phono Plug (RCA) Connector ............6 Figure 3 – Option Select (DIP) Switch Diagram ..........7 Figure 4 – Trigger Plug Pin Numbers ...............10 Figure 5 – Wall Mount Diagram................11 AL-500P-II 12/15/1999... -
Page 4: Introduction
MONITOR SPEAKER is preset and can not be adjusted. POWER LAMP - Shows that the unit is "on" and operational. LOAD LAMP & PLAY LAMP - These lamps show the status of the AutoLoader 500P as indicated by the following table: AL-500P-II 12/15/1999... -
Page 5: Rear Controls And Connections
12 VDC - To connect the external DC power pack. POWER OFF / ON - This switch enables external power to the system. Note: The AL500P does not contain a battery backup system. Without system power, the stored messages are lost. AL-500P-II 12/15/1999... -
Page 6: Bottom Controls
OPTION SELECT SWITCHES - This control located on the bottom of the unit, the Option Select Switches provides the user the capability to configure the AutoLoader 500P to meet their individual needs. These switches are used to select continuous or external trigger message play, bandwidth, and tape preview on/off. AL-500P-II 12/15/1999... -
Page 7: Table 2 - Option Select Switches
8 Min. 16 Min. 32 Min. 3.5 KHz 34KBps 2 Min. 4 Min. 8 Min. 16 Min. 7.0 KHz 69 KBps 90 Sec. 3 Min. 6 Min. 12 Min. 7.0E KHz 92 KBps Table 3 – Message Memory Table AL-500P-II 12/15/1999... -
Page 8: Installation
Connect a cable from the AUDIO OUTPUT jack on the rear of the unit to the sound system input. Follow the Message Loading instructions below to load the unit with audio. Once loaded, adjust the MESSAGE LEVEL control and or the OUTPUT IMPEDANCE for optimum levels over the sound or telephone system. AL-500P-II 12/15/1999... -
Page 9: Tape Loading
In Continuous Play mode (Option Select Switch #1 = OFF), once the audio message is loaded it is played constantly, upon reaching the end of the message, it is immediately started again. External Trigger External Trigger operation (Option Select Switch #1 = ON) allows the message to AL-500P-II 12/15/1999... -
Page 10: Tape Preparation
Start the recording no further than 20 seconds from the beginning of your tape. The message must not have levels averaging less than -25 db for longer than 5 seconds. Any passages at less than -25 db longer than 5 seconds are interpreted the end of the load. AL-500P-II 12/15/1999... -
Page 11: Wall Mount Instructions
WALL MOUNT INSTRUCTI WALL MOUNT INSTRUCTIONS WALL MOUNT INSTRUCTI WALL MOUNT INSTRUCTI Figure 5 – Wall Mount Diagram AL-500P-II 12/15/1999... - Page 12 Nel-Tech's prior written consent. Information contained herein is subject to change without prior notification. Nel-Tech Labs, Inc. provides this manual without warranty of any kind, expressed or implied. This user's manual may contain technical and/or typographical errors. Printed in the U.S.A. AL-500P-II 12/15/1999...
Need help?
Do you have a question about the AL-500P-II and is the answer not in the manual?
Questions and answers