Table of Contents
Advertisement
Advertisement
Table of Contents
Troubleshooting
Subscribe to Our Youtube Channel
Related Manuals for hurlcon Filtrite CX Series
Summary of Contents for hurlcon Filtrite CX Series
- Page 1 PREMIUM SALT CHLORINATOR INSTALLATION AND OPERATING INSTRUCTIONS...
-
Page 2: Table Of Contents
CONTENTS General Overview ..........................3 Chlorinator Control Installation ......................3 Cell Installation ............................. 4 Pool Preparation ........................... 5 User Panel Functions ..........................5 Programming ............................6 Chlorine Output ............................ 7 User Mode ............................7 Warnings Display ..........................8 Chlorine Output Level .......................... 8 Safety Backwash ........................... -
Page 3: General Overview
GENERAL OVERVIEW Congratulations! You have purchased a quality Filtrite CX series salt chlorinator. Please read the instructions carefully and your purchase will provide you with years of trouble free use. Your Filtrite chlorinator works by converting some of the salt in your pool into chlorine which starts to destroy algae, bacteria and viruses in your pool water thereby sanitising your pool. -
Page 4: Cell Installation
CELL INSTALLATION The chlorinator cell must be located last in the pipe work just prior to the return to the pool. If valves are installed between the Chlorinator and the pool outlet, it is essential that they cannot deadhead the pump. If the pressure in the cell exceeds 150kPa and/or the water temperature exceeds 40 degrees C, the cell may fail. -
Page 5: Pool Preparation
POOL PREPARATION The chlorinator requires a minimum 3,000ppm of salt but the recommended level is 4,000ppm therefore add 4kg’s of salt for every 1000 litres of water (a typical pool of around 50,000 litres requires 200kg of salt). Salt should always be added at the shallow end of the pool and allowed to dissolve. Running the pump will mix the water and speed the dissolving process. -
Page 6: Programming
PROGRAMMING Setting Current Time/Day Select POOL MODE Standby/Off (a) Press the CLOCK button Press DAY to change the current day. (c) Press HOUR to move the display cursor to the hour digits and then use the up and down arrows to the right of the display to change the current hour (d) Press MIN to move the display cursor to the min digits and then use the up and down arrows to the right of the display to change the current minutes... -
Page 7: Chlorine Output
The Chlorinator/Pump will run continuously. Standby/Off The Chlorinator/Pump will stay off continuously. SPA MODE: Sends a message to other Filtrite by Hurlcon equipment (if fitted) to go to Spa mode and turns the pump on Inst339 Filtrite Salt Chlorinator V09.20... -
Page 8: Warnings Display
WARNINGS DISPLAY Apart from messages displayed on the User display, there are two warning indicators. (a) LOW SALT: This indicates that the concentration of salt has reduced within you pool. To rectify, visit your local Clark Rubber Pool & Spa shop with a water test and they will guide you on the correct amount of salt to add. (b) NO FLOW: This indicates that the chlorinator thinks that there is no flow to the cells. -
Page 9: Safety Backwash
SAFETY BACKWASH When backwashing your sand filter, the pool water does not pass through the cell. During the backwash and rinse process, many chlorinators might build up potentially explosive hydrogen gas in the chlorinator cell. The Safety Backwash function allows the pump to turn on without applying power to the chlorinator cell. This prevents the build up of hydrogen gas during the back wash and rinse process. -
Page 10: General Operation / Pool Chemistry
GENERAL OPERATION / POOL CHEMISTRY Setting the right chlorine output and filtration time Your Filtrite chlorinator must be run every day to ensure that your pool is correctly sanitised. As the sun dissipates chlorine, running times are higher in the summer compared to the winter. It is recommend that you initially run you chlorinator at maximum output Summer Operation You should set your chlorinator to operate for 8 to 10 hours per day. -
Page 11: Chlorinator Maintenance And Troubleshooting
CHLORINATOR MAINTENANCE AND TROUBLESHOOTING If the supply cord is damaged, it must be replaced by a qualified person in order to avoid a hazard. Cell Maintenance Your Filtrite chlorinator has an automatic cleaning feature that under normal conditions, will keep the cell plates clear of deposits of salt and calcium. -
Page 12: Maintenance Of Your Chlorinator
Maintenance of your Chlorinator Maintenance Schedule: Performing these checks and maintenance will identify parts that have worn and require repair/replacement before further serious damage is sustained. A small amount of regular care and attention to your pool equipment will help ensure long life and trouble free performance. To protect against extremes of temperature, your unit is vented to allow expensive electronics to cool. -
Page 13: Troubleshooting
TROUBLESHOOTING Your Filtrite chlorinator has diagnostic and safety features to make it easy to maintain your system. The table below summarises potential faults and their causes. Fault Indication Potential Cause Remedy No Flow Pump turned off/disconnected or valves Ensure valves/pump on closed Blue wire disconnected from cell Connect Blue sense wire to cell... -
Page 14: Warranty
WARRANTY Fluidra Group Australia Pty Ltd (ABN 87 002 641 965) provides the following express warranty for this product. Product Name Warranty Period Limitations / Enhancements FILTRITE CX CHLORINATOR 3 years EXPRESS WARRANTY Fluidra Group Australia Pty Ltd (Fluidra) warrants that its Products will be free from defects in materials and workmanship when used in domestic swimming pools. - Page 15 Product or whether warranty service will be provided in the field, repaired at a Fluidra workshop or at the premises of an authorized Fluidra warranty agent. If it is necessary for the Purchaser to incur freight charges in making a valid claim under this warranty, Fluidra, as the case may be, will reimburse the Purchaser for charges reasonably incurred upon proof of the charges.
- Page 16 Clark Rubber Franchising Pty Ltd. ACN. 065 708 723 www.clarkrubber.com.au email: Information and specifications subject to change without notice. Inst339 Filtrite Salt Chlorinator V09.20...
Need help?
Do you have a question about the Filtrite CX Series and is the answer not in the manual?
Questions and answers