Advertisement
Quick Links
Advertisement
Summary of Contents for FANTEM FT132
- Page 1 In-Wall Smart Switch (Dual)
- Page 2 Fantem In-Wall Smart Switch (Dual) Fantem In-Wall Smart Switch (Dual) is a low-cost Z-Wave Switch specifically used to enable Z-Wave command and control (on/off) of any wall switches. It can report immediate wattage consumption or kWh energy usage over a period of time. In the event of power failure, non-volatile memory retains all programmed information relating to the unit’s operating status.
- Page 3 S1 – External switch control for load 1 S2 – External switch control for load 2 Install the In-Wall Smart Switch (Dual). Important: A licensed electrician with knowledge and understanding electrician systems and electrical safety should complete the electrical installation. 1.
- Page 4 In some cases, you may have some loads just only can be used on the voltage of DC24V and hope that it still can be controlled by the In-Wall Smart Switch (Dual), so please refer to the following diagram to achieve this: Note: The “IN”...
- Page 5 If the output loads should be only powered by AC120V or AC230V, you can change the wire connection as below: Note: The “IN” terminal should be connected to the “Live” of AC 120V/230V power wire. All above wiring diagrams show that the In-Wall Smart Switch (Dual) uses 2-Way or momentary button switches as the external manual switch for 2-Way connection.
- Page 6 3. Install In-Wall Smart Switch (Dual) to the gang box. a. Live/Hot wire connection: Connect the Live/Hot wire to the “L” terminal on the In-Wall Smart Switch (Dual). b. Neutral wire connection: Connect the Neutral wire to the “N” terminal on the In-Wall Smart Switch (Dual).
-
Page 7: Quick Start
c. Reinstall the In-Wall Smart Switch (Dual) to the gang box. d. Reinstall the cover onto the gang box. Note: 1) The gang box should be sized 3 × × 2 .75 inch/ 75 × × 7 0 mm or larger, minimum volume 14 in / 230cm 2) Use flexible copper conductors only. -
Page 8: Advanced Functions
Switch (Dual) is entering into pairing mode. 3. If the In-Wall Smart Switch (Dual) has been successfully added to your Z-Wave network, its RGB LED will be solid. If the pairing was unsuccessful, the red LED will be on for 2 seconds and then remain a colourful gradient, repeat the instructions above from step 1. - Page 9 Smart Switch (Dual). Note: The model FT140 In-Wall Switch (Dual) does not have the ability to monitor energy consumption. The model FT132 In-Wall Smart Switch (Dual) supports the energy metering feature and you can see the word “Smart” on its packaging box.
-
Page 10: Technical Specifications
LED will be solid for 2 seconds and then remain the colourful gradient status as a confirmation. Technical specifications. Model number: FT132/FT140 Power input: 120VAC to 240VAC, 50Hz to 60Hz. Rated output: 5A per channel for resistive load. Total current: Max 10A.