Miele HG07 Operating Instructions Manual page 83

A stopcock with a ¾" threaded union is
required for the connection. If a
stopcock is not available, a qualified
plumber should connect the dishwasher
to the mains water supply.
A non-return valve is not required. The
appliance meets the requirements of
the applicable DIN standards.
The water-connection pressure needs
to be between 50 and 1000 kPa. If the
water-connection pressure is too high,
a pressure reducing valve must be
fitted.

Risk of damage from leaking
water.
The connection point is subject to
mains water pressure. Water leaking
from it can cause damage.
You should therefore open the
stopcock slowly and check for leaks.
Correct the position of the seal and
screw thread if appropriate.

Risk of damage due to excessive
pressure.
A brief increase in the water pressure
can damage components of the
dishwasher.
This dishwasher must only be
operated when it is connected to a
fully vented plumbing system.

Risk of electric shock from mains
voltage.
There are electrical components in
the water inlet hose.
The inlet hose must not be shortened
or damaged in any way (see
illustration).
Installation
83