FCC REGULATORY STATEMENTS Part15, Class A This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: This device may not cause harmful interface, and This device must accept any interface received, including interface that may cause undesired operation.
Page 3
INTRODUCTION This PCMCIA Fast Ethernet PC Card is designed for any Notebook PC with a PCMCIA or CardBus PC Card slot. With this PC Card, users can hook up to their Ethernet LANs at the speed of 100Mbps as 10 times faster than traditional LAN environment.
HARDWARE INSTALLATION 1. Locate the PCMCIA slot of your system. 2. Align the PCMCIA Fast Ethernet PC Card toward the PCMCIA slot. Push evenly and steadily until it is seated. 3. Plug one end of an Ethernet Cable into the attached RJ-45 port.
SOFTWARE INSTALLATION Installation for Windows 95 The installation procedures for the network driver may vary slightly depending on the version of Windows 95 you are using and also your current system configuration. 1. Once the PCMCIA Fast Ethernet PC Card is connected to your computer, Windows 95 will automatically detect the new hardware device.
Page 6
floppy drive. When Windows prompts you What do you want Windows to do? Select Search for the best driver for your device. (Recommended) Click Next. 3. Follow the on-screen instruction to proceed. 4. The installation program will proceed automatically. - 4 -...
Page 7
5. If you are asked to insert Windows 98 CD- ROM in the selective drive, please do so to have Windows copy all the necessary files to your system. When the following window appears, click Finish. 6. Click Yes to restart your computer. - 5 -...
Page 8
Installation for Window ME Once the PC Card is well connected to your computer, Windows ME will automatically detect the new device. Select Automatic search better driver (Recommended) … and click Next. Insert the device driver disk into the floppy disk drive on your system.
Page 9
Installation for Windows NT 4.0 This section describes the installation for Windows NT under the condition that Windows NT is already installed in your computer. If your computer is not yet networking installed, refer to the Windows documentation for details. Also remember to have your original Windows NT CD-ROM handy...
Page 10
Base, Interrupt, and Memory values for the card. Good values to start with are 300 (for the I/O Base) and 5 (for the IRQ). 7. When you're finished, click OK. Windows NT will copy necessary files to your computer. 8. When the Network window reappears, click on the Bindings tab.
Page 11
3. Windows will again prompt you a Found New Hardware Wizard dialog box. In this time, select Floppy disk drives and insert the driver diskette. Press Next. When asked for the original Windows 2000 CD/disks, please follow the on-screen instruction. 4.
Page 12
7. For the first time installation, click Network icon in Control Panel to add Protocols, Client and Service if needed. 8. Reboot your computer to activate the new device. Installation for Windows XP Once the device is well connected, Windows will detect the new device and prompt you to insert the network device driver.
Page 13
Click Continue Anyway to proceed. Wait while Windows copies appropriate driver to your system. Click Finish. The software installation for this network device is now completed. - 11 -...
Page 14
Reboot your computer to activate the new device. - 12 -...
DECLARATION OF CONFORMITY CE = European Community Conformity Mark We, Manufacturer/Importer Longshine Technologie (Europe) GmbH An der Strusbek 9 22926 Ahrensburg Germany Declare That The Product LCS-8538TXN 10/100 Fast Ethernet PCMCIA Card Is In Conformity With: Standards Results EN 55022:1998...
Need help?
Do you have a question about the LCS-8538TXN and is the answer not in the manual?
Questions and answers