Declaration of Conformity (DoC) 1 Introduction The CAMAG TLC Plate Heater III is used to heat a TLC or HPTLC plate to a given temperature after developing, dipping or spraying. An ultra-flat heating surface and high-precision temperature control allow exceptionally uniform heating of the exposed plate surface.
Page 3
Only authorized personnel may open the instrument. Service and repair are only to be performed by trained specialists. Use spare parts and consumables supplied by CAMAG only. The warranty is voided if parts from other sources are used. Check the service manual before you start service to reduce product-specific risks •...
Unpacking/Installation • See original manufacturers' manuals for further safety data on third party equipment supplied with the system • The safety of any system incorporate with the equipment is the responsibility of the assembler of the system • The use of the instrument without adequate ventilation to outside air may constitute a health hazard depending on the substances in use •...
15 minutes before use • Note that temperature and exposure time cannot simply be taken from another type of heating such as a drying cabinet and used for the CAMAG TLC Plate Heater III 4 Maintenance 4.1 Cleaning •...
Maintenance • Wet cleaning: with standard domestic cleaning agents for ceramic cooker tops. Use respective cleaning solvent when dangerous solvents where used. • Make sure that no liquid ever enters the inside of the device. 4.2 Decontamination If correctly used, the instrument does not need to be decontaminated. If the instrument is used in a manner not specified in this manual, follow the respective safety regulations/guidelines to decontaminate the instrument if applicable.