Cadillac XT6 Owner's Manual page 42

Cadillac XT6 Owner Manual (GMNA-Localizing-MidEast-14574703) - 2021 -
CRC - 7/15/20
42 SEATS AND RESTRAINTS
3. Start the vehicle with the initial
key or RKE transmitter. The DIC
should display the driver number
of your RKE transmitter.
Saving Memory Positions
Read these instructions completely
before saving memory positions.
To save preferred driving positions
1 and 2:
1. Turn the vehicle on or to ACC/
ACCESSORY.
A DIC welcome message may
indicate driver number 1 or 2.
2. Adjust all available memory
features to the desired driving
position.
3. Press and release SET; a beep will
sound.
4. Immediately press and hold the 1
or 2 memory button matching the
above DIC welcome message until
two beeps sound.
If too much time passes between
releasing SET and pressing 1, the
memory position will not be saved
and two beeps will not sound.
Repeat Steps 3 and 4.
1 or 2 corresponds to the driver
number. See Identifying Driver
Number previously in this section.
5. Repeat Steps 1 4 for a second
driver using 1 or 2.
To save the position for and Seat
Exit Memory features, repeat Steps 1
4 using . This saves the position for
getting out of the vehicle.
Save preferred memory feature
positions to both 1 and 2 if you are
the only driver.
Manually Recalling Memory
Positions
Press and hold 1, 2, or to recall the
previously saved memory positions if
you are driver 1 or 2 identified in the
DIC welcome message.
To stop Manual Memory recall
movement, release 1, 2, or
any of the following controls:
Power seat
Memory SET
Power mirror, with the driver or
passenger side mirror selected
Power steering wheel, if equipped
Manual Memory recall movement for
1, 2, or buttons may be initiated
and may complete to the saved
memory position if the vehicle is in or
out of P (Park).
Seat Entry Memory
The vehicle identifies the number of
the current driver s RKE transmitter
(1 8). See Remote Keyless Entry (RKE)
System Operation 0 7. If the RKE
transmitter is 1 or 2, and Seat Entry
Memory is enabled in vehicle
personalization, the positions saved to
the same memory button number 1 or
2 are automatically recalled when the
vehicle is turned on, or turned from
off to ACC/ACCESSORY. RKE
transmitters 3 8 will not provide
automatic memory recalls.
To turn Seat Entry Memory on or off,
see Vehicle Personalization Settings
or press
previously in this section and Vehicle
Personalization 0 126.
The shift lever must be in P (Park) to
start Seat Entry Memory. Seat Entry
Memory recall will complete if the