Advertisement
.
Tip: You can run your 200W amp at half power by simply removing one of the fuses. Just
remember to turn down the impedance selector one setting as stated above -if doing this for a
prolonged period.
Note: Speakers must be rated for at least the full rated clean output power of the amplifier (50W,
100W, or 200W depending on your model). Under overdrive conditions, the clean power can be
exceeded by tens of watts, and therefore it is preferable to use speakers whose combined power
rating exceeds the clean power rating. This topic is up for debate as some speaker manufacturers
rate their speakers with this in mind (i.e. four 25W rated speakers may be OK for a 100W amp),
however it is still better safe than sorry!
CAUTION: Always verify a speaker cabinets impedance before using with the amplifier. An
impedance mismatch can potentially damage the amplifier and is not covered under
3
Advertisement
