Installing The Anti-Tip Device; Assembling The Drip Tray; Installing Cap Covers - LG S3RERB Owner's Manual

• Keep the bottom of the cabinet dry when filling
or emptying water tanks. Keep the outside of the
water tanks clean and dry to discourage growth
of mold or mildew.
USING NON-SKID PADS
(OPTIONAL)
Non-skid pads prevent the product from shaking or
shifting when opening or closing the door.
1 Clean the floor to attach the non-skid pads. Use a
dry rag to remove and clean foreign objects or
moisture. If moisture remains, the non-skid pads
may slip.
2 Adjust the level after placing the Styler in the
installation area.
3 Place the adhesive side of the non-skid pad on
the floor.
4 Recheck the Styler's levelness.
Push or rock the edges of the appliance gently to
make sure that the Styler does not rock. If the
Styler rocks, level the appliance again.
• The pads may leave a sticky residue when they
are removed. The residue can be removed with
alcohol.
INSTALLING THE ANTI-TIP
DEVICE
• Appliances can tip, resulting in damage or
injuries. Do not operate the unit without the
anti-tip device in place and engaged.
If an anti-tip device is not properly installed, the
appliance could be unexpectedly tipped by a
child or adult standing, sitting, leaning, or
placing excessive weight on an open door or the
interior parts.
• Install the anti-tip device packed with the S tyler
to reduce the risk of tipping.
Refer to the instructions provided with the antitip
kit for proper anti-tip device installation.
• Check that the anti-tip device is properly
installed.
With the appliance in its final location, make sure
that the slide adjuster on the cord is adjusted
until there is about one inch of slack in the cord.
• The use of the anti-tip device does not preclude
tipping of the appliance when it is not properly
installed.

ASSEMBLING THE DRIP TRAY

Before using the Styler, insert the drip tray onto the
bottom of the cabinet.
1 Hold the
arrow
the
tray
2 Insert one
tray
other.
until
completely
3 To detach, pull
out
If the tray collects water, detach it and empty
the water. After emptying it, re-assemble the
tray.
• Do not operate the S tyler without installing the
drip tray. Doing so could lead to water damage
caused by leaking.

INSTALLING CAP COVERS

1 Line up
nubs
cap
with
holes
top
the
INSTALLATION
tray so
and letter
front of
face up.
side of
first, then
Push the
it slides
in.
one
then the
the
on the
cover
the
in the
corner of
cabinet.
21
the
on
the
the
the
tray
side
other.