Cateye VOLT 400 DUPLEX Manual

HL-EL462RC-H
Manual
Before using the light, read this manual thor-
oughly and keep it for future reference.
Copyright© 2017 CATEYE Co., Ltd.
EL462RCH-170327 1
WARNING!!!
• Be sure to direct the light beam downward so
the driver approaching does not get dazzled.
• Before your trip, please make sure the light is
fi rmly mounted to the bracket and it lights up.
• Always attention to the remaining battery
power by checking the indicator periodically
while using.
CAUTION!
• Do not place it within children's reach.
• In preparation for unexpected battery shutoff,
we recommend you carry a spare cartridge
battery and light.
• This product is water-resistant under normal
daily use and can be used in the rain. Howev-
er, do not intentionally submerge it in water.
• If the light unit or parts become dirty with
mud, etc., clean with a soft cloth which is
moistened with mild soap. Never apply paint
thinner, benzine or alcohol; damage will
result.
LITHIUM-ION BATTERIES
Cautions on recharging
• Avoid charging in direct sunlight or in a
vehicle parked under direct sunlight, and
make sure to charge only when the ambient
temperature is between 41°F and 104 °F
(5 and 40°C).
• Before charging, be sure that no dust or
other foreign objects attach to the USB
plug.
• Do not subject the light to vibrations while
charging.
• Once charging is complete, be sure to
disconnect the USB plug.
Cautions in use
• Charging, discharging, and storing in high
temperatures will cause the rechargeable
battery to deteriorate faster. Do not place
the light inside a vehicle or near a heater.
• When the operating time decreases signifi -
cantly, the battery life is close to an end.
Replace the cartridge battery with a new one.
Cautions on storage
• Cool and dry storage is recommended.
For long period storage, it is important
to charge the battery 30 minutes every 6
months.
• When you store the cartridge battery alone,
be sure to install the cap. Otherwise, dam-
age or a fi re may be caused by short circuit.
Cautions for dispose
Dispose of used cartridge batteries appropri-
ately according to local regulations.
ENG
Before Initial Use
This unit is shipped
with a small charge
to check the light. Be
sure to charge it before
use, according to the
instructions "HOW TO
CHARGE".
1 HOW TO CHARGE
USB cable
2
1
Standard charging time
1. Connect the light unit to your PC or a com-
mercial USB battery charger using the USB
1
cable. (Fig 1
The switch indicator turns on and charging
starts.
Indicator light:
Illuminated in red
Indicator light: Off
* When your PC is in sleep state, the unit can-
not be charged.
2 HOW TO MOUNT TO A HELMET
1
A
1. Securely fasten the helmet mount to the front
part of the helmet, wrapping the bracket strap
through the air vents on the helmet. (Fig 2
A
The bracket strap can be attached
either vertically or horizontally.
2. Mount the light unit onto the helmet mount.
( )
2
Light unit
Taillight integrated
cartridge battery
(BA-2.6-R)
To PC or USB
battery charger
Charge jack cover
6
Approx. h
( USB 2.0 )
2
– ).
Charging
Charging is completed
B
Bracket strap
)
1
USB cable
(MICRO USB)
Optional
Charging on the cradle
Cartridge battery
Fast charging cradle 2
IN OUT
MICRO USB
* We recommend using 500+mAH (USB2.0)
USB battery charger.
* If using the Fast charging cradle2 (optional),
the indicator on the cradle turns on.
2. After charging is completed, remove the USB
cable, and install the charge jack cover.
* Charging and lighting times are approximate
values, and will vary by environmental and
user conditions.
* The optional cradle2 not only lets you charge
the battery by itself, but also gives you the
option of using it as a mobile battery.
2
Remove
3
Release button
3. Wear the helmet and adjust the angle of the
beam. ( )
3
4. To remove the light unit, pull out it forward
while pressing down on the release button
( ).
4
CAUTION!:
Check the screw on the bracket periodically,
and use it without any loosing. (
Helmet mount
USB
Light unit
4
B
)