Durite 0-450-90 Quick Start Manual

Micro Blow Torch with Diamond Cut Aluminium Handle
Part 0-450-90

WARNINGS

Before using this unit please read these instructions carefully. Take special care to follow
the warnings and safety suggestions listed below. Keep these instructions for future refer-
ence.
*Contains flammable gas under pressure.
*Never puncture or put in fire.
*Use only Butane lighter fuel.
*Do not use an appliance which shows any damage.
*Close the taps, valves, adjusted knobs of the appliance before connection or refill.
*Refill the tank in a well-ventilated place, in a flame or ignition source free atmosphere, far from other
persons.
*Do not smoke while refilling.
*Do not put an ignited appliance down.
*Refilling by an inadequate method may lead to serious accidents.
*Verify that seals if any at the connection are well placed and not damaged.
*Check the hoses for damage.
*Do not work in enclosed space, maintain good ventilation.
*Work only in a clean place, far from combustible or greased materials.
*Wear eye-protection and gloves for handlng hot appliances.
*Avoid breathing welding / soldering fumes
*Allow the appliance to cool down before storing
*Store and transport the containers upright.
*Use only specified spare parts.
*Never try to repair a damaged tool.
*Do not throw the appliance or the container into fire.
*Avoid contact of flux with skin and eyes.
*Always have a fire extinguisher and a bucket of water near the torch and work area.
*Do not touch the exhaust port with metal or any hard item.
*Do not store in temperatures over 120F(49C) (Such as in a car in hot weather)
*After using the micro torch, the safety lock should be engaged.
*Do not point the flame directly at any person.
*Be careful when using the micro torch in bright light because the flame is not very visible.
0-450-90 LEAF
www.durite.co.uk