Download Print this page

Gemini 807 Manual page 2

Opening detector

Advertisement

UK
OPENING DETECTOR GEMINI 807
Gemini 807 is a radio-opening detector useful to protect window and door
frames with mobile shutter. The sensor is combinable with Gemini's alarm
systems equipped with radio receiver.
ATTENTION
!
In order to combine the sensor to the alarm system, please follow the
instructions in the alarm manual.
It is suggested to check the alarm type to which this device should be
combined with, since the sensor could be not operating in old models.
INSTALLATION AND FUNCTIONNING
ATTENTION
!
You are kindly requested to pay attention during the punching phases, in
order to avoid damages on rear parts (i.e. sunshade curtains).
The opening detector must be mounted and tightened on the fixed part of the
shutter to be protected, using the supplied screws.
The button must be in contact with the mobile shutter; in this way, the sensor is
able to detect any movement of the shutter.
After having tightened the sensor, open the shutter and check the LED's
turning on; it indicates that the alarm signal transmission is carried out and that
the sensor is operating properly.
If the LED is not turned on, check the sensor's position respect to the mobile
shutter or, use the supplied adaptor, if necessary.
N.2 SCREWS
3.5 x 9,5mm
N.2 SCREWS
3.5 x 9,5mm
N.2 SCREWS
3.5 x 13mm
ADAPTER
BATTERY REPLACEMENT
To check the charge status of internal batteries, press and then release the
sensor's button.
The battery status is optimal if the LED is turned on. A battery replacement is
required in case the LED's light is weak.
For battry replacement follow the indication reported below.
1- Open the battery compartment
cover by lifting it from
the little tooth
2- Remove the two uncharged batteries,
3- Introduce two new
3V CR1616 batteries,
keeping the positive pole
turned toward the upper side
4- Lean the battery compartment cover on
the device cover as shown in the figure
and slide it toward the LED.
When the cover is stopped,
fix it by pushing its rear part.
ATTENTION
!
Use only batteries of Cr1616 type; we suggest to not throw the exhausted
batteries in the normal garbage bins, but to use the specific containers for
their disposal.
from their lamellar holder
AC2713 Rev.00

Advertisement

loading