Operating The Traction Drive; Operating The Speed Selector; Operating The Auger/Impeller Drive - Toro Power Max e26 Operator's Manual

Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust
it properly, if necessary; refer to
the Operation of the Traction Drive (page 13)
for more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 23)
to an Authorized Service Dealer for service.
1. To engage the traction drive, squeeze the left
(traction) lever to the handgrip
Figure 20
2. To stop the traction drive, release the traction
lever.
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position (Figure 21). The lever locks in a notch at
each speed selection.
9 Checking
Checking and Adjusting
or take the machine
(Figure 20).
Operating the
Auger/Impeller Drive
1. To engage the auger/impeller drive, squeeze
the right (auger/impeller) lever to the handgrip
(Figure 22).
2. To stop the auger and impeller, release the right
lever.
g001011
Important:
auger/impeller lever and the traction lever,
the traction lever locks the auger/impeller
lever down, freeing your right hand. To
release both levers, simply release the left
(traction) lever.
3. If the auger and impeller continue to rotate when
you release the auger/impeller lever, do not
operate the machine. Check the auger/impeller
cable; refer to
Auger/Impeller Cable (page 24)
necessary. Otherwise, take the machine to an
Authorized Service Dealer for service.
WARNING
If the auger and impeller continue
to rotate when you release the
auger/impeller lever, you could seriously
injure yourself or others.
Do not operate the machine. Take it to an
Authorized Service Dealer for service.
18
Figure 21
Figure 22
When you engage both the
Checking and Adjusting the
and adjust it if
g322971
g001013