VISIT OUR WEBSITE TO: Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support SAFETY INFORMATION Before the installation and use of the appliance, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage that are the result of incorrect installation or usage.
By clients in hotels, motels, bed and breakfast and other – residential type environments. To avoid contamination of food respect the following • instructions: do not open the door for long periods; – clean regularly surfaces that can come in contact with food –...
• Always take care when moving the appliance as it is heavy. Always use safety gloves and WARNING! Risk of injury, burns, enclosed footwear. electric shock or fire. • Make sure the air can circulate around the appliance. • At first installation or after reversing the door wait at least 4 hours before connecting the The appliance contains flammable gas, appliance to the power supply.
CARE AND CLEANING DISPOSAL WARNING! Risk of injury or damage WARNING! Risk of injury or to the appliance. suffocation. • Before maintenance, deactivate the appliance • Disconnect the appliance from the mains and disconnect the mains plug from the mains supply.
Page 6
DIMENSIONS Overall dimensions ¹ Space required in use ² 1772 ² the height, width and depth of the appliance including the handle, plus the space necessary for free circulation of the cooling air ¹ the height, width and depth of the appliance without the handle and feet Overall space required in use ³...
socket is not earthed, connect the appliance to necessary to allow door opening to the minimum a separate earth in compliance with current angle permitting removal of all internal equipment regulations, consulting a qualified electrician. • The manufacturer declines all responsibility if LOCATION the above safety precautions are not observed.
TEMPERATURE REGULATION To freeze fresh food activate the To operate the appliance, touch the temperature FastFreeze function at least 24 hours regulator until the LED corresponding to the before placing the food to complete required temperature lights up. Selection is pre-freezing.
MOVABLE SHELVES STORAGE OF FROZEN FOOD The walls of the refrigerator are equipped with a When activating an appliance for the first time or series of runners so that the shelves can be after a period out of use, before putting the positioned as desired.
• Fridge: Do not set too high temperature to save • Do not eat ice cubes, water ices or ice lollies energy unless it is required by the immediately after taking them out of the freezer. characteristics of the food. Risk of frostbites.
soap to remove the typical smell of a brand-new About 12 hours prior to defrosting set product, then dried thoroughly. a lower temperature in order to build up sufficient chill reserve in case of CAUTION! Do not use detergents, any interruption in operation. abrasive powders, chlorine or oil- based cleaners as they will damage A certain amount of frost will always form on the...
TROUBLESHOOTING WARNING! Refer to Safety chapters. WHAT TO DO IF... Problem Possible cause Solution The appliance does not oper- The appliance is switched off. Switch on the appliance. ate. The mains plug is not connec- Connect the mains plug to the ted to the mains socket cor- mains socket correctly.
Page 14
Problem Possible cause Solution Door does not open easily. You attempted to re-open the Wait a few seconds between door immediately after closing. closing and re-opening of the door. The lamp does not work. The lamp is in stand-by mode. Close and open the door.
Problem Possible cause Solution Temperature cannot be set. The "FastFreeze function" is Switch off "FastFreeze func- switched on. tion" manually, or wait until the function deactivates automati- cally to set the temperature. Refer to "FastFreeze function" section. The temperature in the appli- The temperature is not set cor- Set a higher/lower tempera- ance is too low/too high.
NOISES SSSRRR! BRRR! CLICK! HISSS! BLUBB! TECHNICAL DATA The technical information is situated in the rating plate on the internal side of the appliance and on the energy label. INFORMATION FOR TEST INSTITUTES Installation and preparation of the appliance for any as stated in this User Manual at Chapter 3.