RT LARGE CLAPTON Installation Instructions

Advertisement

500MM

Installation and aftercare instructions:

Before you start it is recommended that the mirror is secured to a suitably reinforced wall to ensure stability. Wall plugs
are only suitable for solid stone/brick walls. For plasterboard walls use specialist wall plugs (not supplied).
Wear suitable eye protection when drilling. Take care when using power tools near water the use of a residual current
device (RCD) is recommended. Beware of hidden pipes or cables. Take care when drilling tiled surfaces as the drill might
slip. Use a piece of masking tape to prevent the drill from wandering.
MRTL261 CLAPTON
(DL-23)
Features:
High density LED technology
Touch sensor switch
SQ Class ultra-clear flat glass surface
Copper free silver mirror with Valspar Anti-Oxidation coating
LED lifespan over 100,000 hours
Compliant with CE, EMC, LVD, IP44, RoHS
128MM
700MM
Unit 2 Bluebell Industrial Estate, Dublin 12
Tel: 01 450 4307 Email:
sales@rtlarge.ie
www.rtlarge.ie
134MM
232MM
-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CLAPTON and is the answer not in the manual?

Questions and answers

Summary of Contents for RT LARGE CLAPTON

  • Page 1 MRTL261 CLAPTON (DL-23) Features: High density LED technology Touch sensor switch SQ Class ultra-clear flat glass surface Copper free silver mirror with Valspar Anti-Oxidation coating LED lifespan over 100,000 hours Compliant with CE, EMC, LVD, IP44, RoHS 500MM 134MM 232MM...
  • Page 2 Installation Procedure IMPORTANT: ALLWAYS SWITCH OFF THE ELECTRICAL SUPPLY AT THE MAINS DURING INSTALLATION AND MAINTENANCE. 1. Before installation. Decide on a desired location for the mirror. Be mindful of hidden water pipes or electrical cables behind the wall. It is recommended that infrared sensor (if applied) is kept a minimum distance of 150mm from the adjacent wall.
  • Page 3 Operating Instructions Lighting is turned on/off using the touch sensor switch on the lower centre of the mirror surface, to operate, cover the touch zone in the circle with your finger, please note full cover of the circle is required, the sensor only reacts to a finger touch, finger nails will not work.

This manual is also suitable for:

Mrtl261

Table of Contents