Adjusting Cutting Height - Brave BRPRC108HEB Owner's Manual

The tongue is equipped with a screw pin shackle clevis to provide movement in all directions on
rough uneven ground. To prevent loss of the screw pin due to vibration or debris, place the screw
pin through the tow vehicle hitch and clevis and turn the screw pin until snug.
The tongue is designed to adjust from left to right within the hitch pivot. This allows the mowers
position to be varied behind the tow vehicle. This is accomplished by pulling the 5/16" wire lock
pins out and choosing two other hole locations on the tongue. See Figure 6.
B. ADJUSTING CUTTING HEIGHT
WARNING: Shut off the engine and allow the mower blades to come to a complete stop
before adjusting the cutting height.
Mower Blade
Lower Edge of
Deck
Smooth Surface
BRPRC108HE, REV B
Directly Behind
Figure 7: Rough Cut Tow Behind Towing Suggestions
Figure 8: Adjusting Rough Cut Mower Cutting Height
Offset
Measure This Distance
and Add 1-5/16" to get
Cutting Height
10
Adjustment Crank: Roughly 8
turns equals 1.0"
Cutting Height
1-5/16"
REV 3/20