Advertisement
Installation Instructions for 81026
Cordless Grease Gun
20 V Lithium ion Battery with LCD, 2-Speed
WARNING
Please read this manual prior to installation or use of this tool for your safety.
Failure to follow instructions and safety precautions may result in serious injury.
Please keep this manual nearby for future reference.
Intended Use
JEGS battery grease gun was exclusively designed to pump and dispense lubricant using 20V
battery power. Do not exceed the maximum specification ratings.
Safety Instructions
WARNING!
Read all safety warnings and instructions carefully.
Failure to follow the warnings and instructions may result in electric shock, fire or serious
injury.
1
Work Area Safety
1.1
Keep work area clean and well lit. Cluttered or dark areas invite accidents.
1.2
Do not operate cordless grease gun in explosive atmosphere, such as in the presence of
flammable liquids, gases or dust. It may ignite the dust or fumes.
1.3
Keep children and bystanders away while operating the cordless grease gun. Distractions can
cause you to lose control.
2
Electrical Safety
2.1
Avoid body contact with earthed or grounded surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric shock if your body is earthed or grounded.
2.2
Do not expose cordless grease gun to rain or wet conditions. Water entering will increase the
risk of electric shock.
2.3
Be sure the switch is released before loading the battery pack.
1-800-345-4545 jegs.com
Advertisement
Table of Contents
Related Manuals for Jegs 81026
Summary of Contents for Jegs 81026
- Page 1 Failure to follow instructions and safety precautions may result in serious injury. Please keep this manual nearby for future reference. Intended Use JEGS battery grease gun was exclusively designed to pump and dispense lubricant using 20V battery power. Do not exceed the maximum specification ratings. Safety Instructions WARNING! Read all safety warnings and instructions carefully.
- Page 2 Extreme pressure may cause nozzle extension or whip hose to burst. Use only approved hoses and follow whip hose instructions and warnings. When unpacking, check it to make sure all the parts shown on the parts list are included. 1-800-345-4545 jegs.com...
-
Page 3: Specifications
This could damage the motor or cause fire. Use only accessories that provided with this tool. Use other accessories which is not provided with this tool may create risk of injury. Do not exceed the maximum specification ratings under any circumstances. 1-800-345-4545 jegs.com... - Page 4 Use vent valve to expel air pockets. Recharge the Battery LCD display the battery is low. Recharge the battery. Clear Reading Press button B for 3 minutes to clear display of the previous reading. 1-800-345-4545 jegs.com...
-
Page 5: Safety Instructions For Battery & Charger
Unplug charger from outlet before any cleaning to avoid electric shock. Do not cover the charger and battery with anything while charging. Charge battery only at ambient temperatures between 10℃ to 40℃. Do not use this charger to charge another battery. 1-800-345-4545 jegs.com... -
Page 6: Charger Operation
Allow the battery pack to cool to room temperature before charging for best charging. Important note: When battery pack is fully charged, disconnect the charger from the power source and remove the battery pack from the charger 1-800-345-4545 jegs.com... - Page 7 4. Remove the pull tab from grease cartridge and screw grease tube into cordless grease gun assembly. 5. Release follower rod from slot to allow it to go forward. Purge air from assembly. See air purging instruction. Notice: Reset display reading after purging air. 1-800-345-4545 jegs.com...
- Page 8 1. Free the follower rod from the grease tube assembly cap and depress the vent valve when pushing the follower rod forward. 2. Squeeze the switch vent valve several times to operate gun until trapped air is expelled. Push the follower rod into the grease tube assembly. 1-800-345-4545 jegs.com...
- Page 9 1-800-345-4545 jegs.com...
-
Page 10: Troubleshooting
Follower may be binding in Replace grease tube assembly. grease tube assembly. Battery fails to take a Charger may not have power. Check that receptacle has charge. Battery may be bad. power. Replace battery. 1-800-345-4545 jegs.com...
Need help?
Do you have a question about the 81026 and is the answer not in the manual?
Questions and answers