Advertisement
Installation Reference
Installing a DC Power Cable and an Outdoor Network Cable
Remove the rubber cable trough and waterproof block of the PWR cable hole.
1
PWR cable hole
Connect the DC power connector to the DC power port.
3
Connect the RJ45 connector of the outdoor network
4
cable to the GE1(e) or GE2(e) port.
Waterproof
block
Rubber cable trough
Install a wire clip over the shield layers of the
5
DC power cable and outdoor network cable.
Reinstall the first layer of waterproof cable
6
trough securely.
Rubber cable trough
Loosen the screw on the desired cable clip at
2
the second layer and remove the cable clip.
The shield layers of all DC power cables and outdoor network cables must be grounded using wire clips. Otherwise,
the cables may be damaged by lightning strikes.
Screw the wire clip and ensure that the wire clip is
completely pressed against the shield layer with no
contact of the sheath.
Wire clip
Shield layer
15
The exposed shield layer is so long that it extends to
the waterproof cable trough.
The shield layer is not
fastened using a wire clip.
The shield layer is
The cable is not routed
not exposed.
through the waterproof
cable hole.
Advertisement
