Advertisement
Controller Board Setup - Deluxe
Setup Manual
READ THIS MANUAL THROUGH BEFORE INSTALLING YOUR UNITS TO ENSURE CORRECT
INSTALLATION AND THAT YOU'RE COVERED UNDER WARRANTY.
1. The following manual details the information
and safety precautions needed for the safe
installation of the Armagard deluxe controller
board.
2. All power must be switched off until the
enclosure has been fully assembled and is
ready to use.
3. If your enclosure is for outdoor use, don't
attempt installation in bad weather; use
correct lighting for optimum viewing
conditions.
4. Armagard recommends that the enclosure
should always be secured to the floor before
adjusting the controller board.
YOUR WARRANTY AGREEMENT IS VOID
controller board, for example, drilling, penetrating or soldering onto the board.
FOR BEST PRACTICE
www.Armagard.com
if you perform any modifications to the
mount the controller board using the recommended procedure.
5. Because of its watertight seal, to lock an
enclosure you have to push firmly against
the door and then turn the key.
6. All images used in this manual are for
reference and example purposes only.
7. The final controller board you receive will
differ depending on what has been agreed
on the order with your account manager.
8. Software is compatible with Windows XP
and 7.
Toll Free (US):
Page |
1-866-434-0807
Call (UK):
0121-608-7210
1
Advertisement
Table of Contents
Summary of Contents for Armagard PCB
- Page 1 5. Because of its watertight seal, to lock an and safety precautions needed for the safe enclosure you have to push firmly against installation of the Armagard deluxe controller the door and then turn the key. board. 6. All images used in this manual are for 2.
- Page 2 Setup Kit To reconfigure the controller board, you’ll need the setup kit which is provided by Armagard as an optional extra. 1. USB/IDE setup cable.
- Page 3 LED’s Figure 1 Step 5: Use a crosshead screwdriver to remove the steel lid that covers the PCB board and place the removed washers and nylocs to one side. Step 6: Connect the USB cable into your computer, and then the IDE connector (highlighted red) onto the controller board (figure 2).
- Page 4 Step 8: Once the board is connected to the computer through the setup cable, Windows will automatically start looking for the drivers. To complete the setup, you’ll need to locate the driver called ‘Armagard USB Configurator.INF’, which you placed on your computer desktop earlier. Then simply follow the setup instructions until finished.
- Page 5 5 below. Figure 5 Step 12: The settings for each component can then be changed by selecting the appropriate option from the menu in figure 6. Page | Toll Free (US): 1-866-434-0807 www.Armagard.com Call (UK): 0121-608-7210...
- Page 6 Step 13: Once your settings have been completed, click disconnect on both the terminal window and close the terminal program (figure 7). Then turn off the enclosures power and remove the 3-pin connector. Then secure the steel lid back onto the PCB and turn the power back on.
- Page 7 Step 2: Secure the relevant wires specific to your region into the ‘Neutral (N), Live (L) and Earthed (E)’ outlets (figure 2a). Step 3: When wiring is complete, secure the steel lid back onto the PCB board and turn the power back on.
- Page 8 Make sure to select the window you’re working with properly. If the terminal program still seems unresponsive, press disconnect at the top of the window and then press reconnect to establish a new link.. Page | Toll Free (US): 1-866-434-0807 www.Armagard.com Call (UK): 0121-608-7210...
Need help?
Do you have a question about the PCB and is the answer not in the manual?
Questions and answers