Advertisement
Quick Links
DESCRIPTION
Multichannel switches allow lighting to be controlled of up to four channels. The range is presented with
three models:
•
two channel – SCRF2, three channel – SCRF3 and four channel – SCRF4.
TECHNICAL DETAILS
•
Input voltage: 220-240 V AC/ 50-60 Hz
•
Output channels: 2 (SCRF2), 3 (SCRF3), 4 (SCRF4)
•
Frequency: 2.4 GHz
•
Load per channel: ≤500 W – active load (incandescent lamp)
•
IP rate: IP20
•
Dimensions receiver: 101/48/25 mm
•
Dimensions remote control: 140/20/19 mm
•
Remote distance: up to 30 m (at open area)
•
Working voltage: 2хААА batteries (included)
•
Holder for wall mounting
•
Working temperature: -10⁰ C ÷ +40⁰ C
•
Warranty: 2 years
WIRING DIAGRAM
SCRF2
REMOTE CONTROL
SCRF2
SCRF3
1
1
2
2
3
3
4
4
Multichannel RF remote control switches
≤300 W – capacitive load (energy saving and LED lamps)
SCRF4
Button
1
1
2
2
3
3
4
4
5
6
NOTE: Every multichannel switch is factory paired to its remote
control and is not affected by the operation of other remote controls!
6
5
SCRF3
SCRF2
Turn ON channel А
ON/OFF channel А
Turn OFF channel А
ON/OFF channel В
Turn ON channel B
ON/OFF channel С
Turn OFF all channels
Turn OFF channel B
after 1 minute
Turn ON all channels
Turn ON all channels
Turn OFF all channels
Turn OFF all channels
SCRF4
Function
SCRF3
SCRF4
ON/OFF channel А
ON/OFF channel В
ON/OFF channel С
ON/OFF channel D
Turn ON all channels
Turn OFF all channels
1 1
ver.1.1
Advertisement
Summary of Contents for UltraLux SCRF2
- Page 1 Multichannel switches allow lighting to be controlled of up to four channels. The range is presented with three models: • two channel – SCRF2, three channel – SCRF3 and four channel – SCRF4. TECHNICAL DETAILS • Input voltage: 220-240 V AC/ 50-60 Hz •...
- Page 2 READ THE INSTRUCTIONS BEFORE MOUNTING OR REPLACEMENT • Performing any activity with the power supply on constitutes potential hazard of electric shock. Prior to mounting, power supply must be switched off by using the main switch! • Multichannel switch may only be connected to a properly functioning electrical system with compliance with the applicable standards.
- Page 3 • Remote control RF code learning from receiver Turn off the power supply of the receiver. Press and hold “2” key for 5 seconds until indicator of remote controller turns off. Turn on the power supply of the receiver. Indicator of the remote controller flashes three times after successful code learning.