Centurion AVANTI Coding Instructions

NEW STYLE DIGITAL AVANTI REMOTE

Code Learning – Bulk Code-

1. On the back of control box, short press on the red learn button and LED light will flash &

display. * Long press on button 2 on pre coded remote will do the same as above.

2. Press top button on your handset 2 times (1 second between presses).

If you are coding your wall remote you press the top left button 2 times (1 second between presses).

Led light will flash rapidly indicating the successful coding in of the run function.

If you have more than one remote to code in, please repeat the same process for each individual remote.

3. With bulk coded remotes, the second button down on the handset or the RH top button on the wall remote,

will automatedly be programed to turn the courtesy light on and off without operating the door.

Code Learning- f

The instructions below will allow you to operate 2 Centurion motors from a single remote.

i.e Motor #1 on top button. Motor #2 on another button.

1. On the back of the control box of Motor #1, short press red learn button and LED light will flash & bu will

show on the display.

Use the yellow + Button to scroll through till

Press button on handset you wish to code to operate the Door 2 times (1 second between presses).

LED light will flash rapidly which indicates successful coding in the run button.

4. Repeat above for each individual remote you wish to program to motor #1. Make sure it's the same button

position for all remotes.

5. To program Motor #2 repeat the above instructions but choose a different button on the remote to run

Motor #2 on each remote.

1. Press red LEARN button on opener once. The LED will display bu and the light will slowly flash.

2. Hold green CONFIRM button down for 5 seconds until led light on the opener flashes rapidly.

3. Deleting codes complete.

CODING INSTRUCTIONS

For Garages with only one motor

or Garages with 2 or more openers

NEW STYLE DIGITAL AVANTI OPENER REMOTE CODING INSTRUCTIONS FORM 12.3 CGD INTRANET

(Run) shows on the display screen.

will show on the

Table of Contents

Need help?

Do you have a question about the AVANTI and is the answer not in the manual?

Page 1 Code Learning- f or Garages with 2 or more openers The instructions below will allow you to operate 2 Centurion motors from a single remote. i.e Motor #1 on top button. Motor #2 on another button. 1. On the back of the control box of Motor #1, short press red learn button and LED light will flash & bu will show on the display.
Page 2 2. Carefully remove both batteries out of holder. 3. Replace 2 x CR2016 3V batteries with numbers on batteries facing upwards. 4. Carefully replace batteries with components facing upwards. 5. Replace casing and screws. NEW STYLE DIGITAL AVANTI OPENER REMOTE CODING INSTRUCTIONS FORM 12.3 CGD INTRANET...