Centralite 3-Series Basic Device Manual

Device Overview
Magnet
Magnet
Getting Started
Powering Up and Pairing
1. Pull and remove the "Pull to Pair" tab from the
Micro Door Sensor. The device will power up and
begin searching for a ZigBee network to join.
2. Initiate pairing on the home gateway/hub.
3. The Micro Door Sensor should start the joining
process automatically. While the sensor is
searching for a network, the status LED will
periodically blink blue.
Once the Micro Door Sensor has successfully
joined the network, the status LED will turn solid
blue for 2 seconds, then turn off.
4. Finish pairing setup from your home gateway/hub.
Micro Door Sensor
Sensor
CR-2450 Battery
Battery Tray
Reset Hole
QUICK START GUIDE
Mounting Clips
LED Light Patterns
Pattern
Blue | Blinking
Green | Short
Red | Blinking then
White | Solid
Red | 3 Blink Series
3-Series
Description
Establishing Connect / Joining
Joining Successful
Power Outage /
Emergency Lighting
Low Battery
3320