Advertisement
Assembly
1. Place the top lock (A) over the mailbox (G) so that the holes match the appropriate drilling holes.
2. Screw two screws (B
3. Secure the screws from the inside with two nuts (C).
4. Place the bottom lock (D) so that the holes match the appropriate drilling holes.
5. Screw two screws (B
6. Secure the screws from the inside with two nuts (C).
Attaching the flag
1. Place one washer (H) on the front and one on the rear of the flag (E).
2. Put the flag (E) in the appropriate drilling holes.
3. Screw the long screw (B
4. Secure the screws from the inside with two hexagon nuts (C).
Important notice:
The reprint or reproduction, even of excerpts, and any commercial use, even in part, of this instruction
manual require the written permission of WilTec Wildanger Technik GmbH.
© by WilTec Wildanger Technik GmbH Item 60143–60146, 60337–60340, 60341–60344
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
) into the drilled holes.
1
) into the bored holes.
1
) into the top hole and the short screw (B
2
) into the bottom hole.
1
Page 4
06
2021-1
Advertisement
