CONFORAMA FLORIDA R52001-5-1L Installation Instruction
CONFORAMA FLORIDA R52001-5-1L Installation Instruction

CONFORAMA FLORIDA R52001-5-1L Installation Instruction

Table of Contents

Advertisement

Available languages

Available languages

GB
General Safety Instructions
Read this instruction manual thoroughly before using the appliance and save it for future reference and
if necessary pass the instruction manual on to a third party.
WARNING: When using electrical appliance, basic safety precautions should always be followed to
reduce the risk of fire, electrical shock and personal injury.
1) General
1.
Check if the electrical specifications of this appliance are compatible with your installation.
2.
Unauthorized use and technical modifications to the appliance can lead to danger to life and health.
3.
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
4.
Children shall not play with the appliance.
5.
Cleaning and user maintenance shall not be made by children without supervision.
6.
This appliance is for indoor use only.
7.
Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
8.
Never install the appliance in a moist or wet room.
9.
Be careful when working near the rotating blades.
1
. 0
N
e
v
r e
t a
a t
c
h
h t
11. Switch off the power before connecting or repairing the fan.
12. The electrical wiring must be in accordance with the local regulations.
13. The fan must be properly grounded to avoid the risk of electric shocks.
2) Electrical safety
14. The appliance should be installed by authorized
electrician only acc. to national wiring rules.
Specific Safety Rules
15. The fan is to be installed so that the blades
are more than 2,3 m above the floor and
distance to wall Min 0.5m.
16. The minimum carrying capacity of the outlet box from which the fan is hung must be 40Kg.
17. Install the luminaire into the fan, to make a complete product.
18. The mains supply to this appliance must be via all pole disconnection switch (Live and Neutral wires),
the switch must have a contact separation of at least 3 mm.
19. To reduce the risk of fire or injury, do not use this product in conjunction with any variable (Rheostat)
wall control or dimmer.
20.
The power supply must be disconnected before installation of the fan, or during the maintenance and cleaning,
in case of doubt, contact a qualified electrician.
21.
When changing the bulb, switch off and disconnected from the power supply and allow the old bulb to cool down
before handling.
22.
Regarding the instructions for the fan that intended to be fixed by screws on the method of fixing and how to install
the appliance, thanks to refer to the section "INSTALLATION".
23.
Regarding the method of the cable connection, thanks to refer to the section "INSTALLATION".
24.
Regarding the instructions for the blub replacement and the type reference of the luminaire, thanks to refer to the
section "INSTALLATION".
NO:000
INSTALLATION INSTRUCTION FOR CEILING FAN
MODEL:R52001-5-1L
PRODUCT:FLORIDA
e
a f
n
o t
a
p
o
w
r e
p
o
n i
, t
b
t u
o t
h t
e
c
i e
n i l
g
s t i
e
. f l
500 mm
Wall
2.3 metre
Floor
Page1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FLORIDA R52001-5-1L and is the answer not in the manual?

Questions and answers

Jacques DOUMERGUE
May 17, 2025

j'ai cassé le verre de la lumiere

1 comments:
Mr. Anderson
May 22, 2025

To replace the glass on the CONFORAMA FLORIDA R52001-5-1L light fixture:

1. Assemble the glass shade (abat-jour en verre) onto the ceiling light fixture.
2. Turn the glass shade clockwise to secure it in place.

Make sure the fixture is powered off before performing the replacement.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for CONFORAMA FLORIDA R52001-5-1L

  • Page 1 INSTALLATION INSTRUCTION FOR CEILING FAN MODEL:R52001-5-1L PRODUCT:FLORIDA General Safety Instructions Read this instruction manual thoroughly before using the appliance and save it for future reference and if necessary pass the instruction manual on to a third party. WARNING: When using electrical appliance, basic safety precautions should always be followed to reduce the risk of fire, electrical shock and personal injury.
  • Page 2 Product exploded diagram 1. Canopy Securing Spring Washer 2. Terminal Block 3. Male/Female Connectors 4. Remote Control Receiver 5. Mounting Plate Fixing Flat Washer 6. Mounting Plate Fixing Spring Washer 7. Mounting Plate Fixing Screw 8. Canopy 9. Upper Housing 10.
  • Page 3: Cable Connection

    15. Mounting plate Mount the mounting bracket onto outlet box by the 2 srews, spring washers and flat washers.(Using explosion screws(not provided) for concrete). 16. Ball Joint 8. Canopy 4. Remote Control Receiver Hang the ball joint and the fan onto the Insert the remote control receiver bracket.
  • Page 4: Bulb Replacement

    Fix canopy onto the bracket by tightening the screws. 26. Blade 3. Male/Female Connectors Install fan blade onto blade bracket Insert the male connector into the female by tightening the set screws flat washers connector securely to install the lamp and spring washers.
  • Page 5: Remote Control

    33. Glass Shade Install the glass shade onto the lamp kit by rotating the glass shade clockwise. Direction Switch on fan body controls air movement: Caution: Before using the direction switch, turn the fan OFF and ensure that the fan has stopped rotating to prevent injury to yourself and damage to the motor.
  • Page 6 : Fan Light : Turn on the fan at High speed : Turn on the fan at Medium speed : Turn on the fan at Low speed : Turn off the fan : Light : Turn on the light : Turn off the light REMARK: MODEL NO.AA2 IMPORTANT...
  • Page 7: Consignes De Sécurité

    INSTRUCTIONS D’INSTALLATION DU VENTILATEUR DE PLAFOND MODÈLE : R52001-XY-1L PRODUIT : FLORIDA Consignes de sécurité générales Lisez la notice d’utilisation attentivement et intégralement avant d’utiliser l’appareil et conservez-la pour consultation ultérieure. Si nécessaire, transmettez la notice d’utilisation à un tiers. AVERTISSEMENT : Quand vous utilisez un appareil électrique, respectez toujours un certain nombre de consignes de sécurités élémentaires afin de réduire les risques d’incendie, de choc électrique et de blessure corporelle.
  • Page 8: Vue Éclatée De L'appareil

    VUE ÉCLATÉE DE L’APPAREIL 1. Vis de fixation de la base 2. Bornier 3. Connecteurs mâle/femelle 4. Récepteur des signaux de la télécommande 5. Rondelle plate de fixation de la plaque de montage 6. Rondelle élastique de fixation de la plaque de montage 7.
  • Page 9: Installation Du Ventilateur

    INSTALLATION DU VENTILATEUR 15. Plaque de montage Fixez la plaque de montage au niveau de la sortie des fils électriques avec 2 vis, 2 rondelles élastiques et 2 rondelles plates (Utilisez des chevilles à expansion (non fournies) pour fixer la Ouvrez le carton et sortez le ventilateu plaque dans du béton).
  • Page 10: Remplacement De I'ampoule

    Pour fixer la base sur la plaque de montage, alignez leurs trous latéraux. Soulevez le ventilateur pour que les vis rentrent dans les rainures, puis tournez la base vers la droite Fixez la base sur la plaque de montage en pour que les vis se logent dans les vissant les vis.
  • Page 11 33. Abat-jour en verre Assemblez l’abat-jour en verre sur le plafonnier en le tournant dans le sens des aiguilles d' u ne montre. UTILISATION DE VOTRE VENTILATEUR les mouvements de l’air : Attention : Avant d’utiliser le commutateur du sens de rotation, éteignez le ventilateur et attendez qu’il se soit complètement arrêté pour éviter de vous blesser ou d'endommager le moteur.
  • Page 12: Utilisation De La Télécommande

    UTILISATION DE LA TÉLÉCOMMANDE : Ventilateur : Faire fonctionner le ventilateur à vitesse rapide : Faire fonctionner le ventilateur à vitesse moyenne : Faire fonctionner le ventilateur à vitesse lente Ventilateur Plafonnier : Éteindre le ventilateur. HI (Rapide) ON (Éteint) : Plafonnier MED (moyen) OFF (Allumé)

Table of Contents