HQTELECOM HiQ L03 User Manual

Bluetooth Headphone Selfie User Manual
Model HiQ L03
(1) LED
Charging, red lamp light. Full charged, blue lamp light low battery, red lamp flashing twice, voice prompt

(2) Micro USB Charging Port

(3) Volume+ - Volume up/Previous song, Tap twice-photographing

(4) Multi-function Key

Power on/off(Press about 4 seconds) Pause(Tap)
Redial(Tap twice) Reconnect the missed device(Tap)
Answer or hung up(Tap) Pairing (Press until headset blue and red lamp alternately flashing)
(5) Volume- - Volume down/next song
The procedure for connecting the Bluetooth headset to a mobile phone (Pairing).
STEP 1
Press the HIQ-L03 headset's Multifunction Key for about 4 seconds. This will turn the headset ON and a BLUE
light will begin to flash. To initiate the Pairing Mode continue pressing the Multifunction Key until alternating
RED and BLUE lights begin to flash. This indicates the headset is now in Pairing Mode (The headset will start
searching for other Bluetooth enabled devices).
STEP 2
Open your Mobile Phone's Bluetooth function and search for other Bluetooth devices. You should see "L03"
show in the search results.
STEP 3
Press the HIQ-L03 Headset's Multifunction key to make the connection. When the connection is successful the
BLUE light will begin to flash.
STEP 3
The HIQ-L03 headset battery working time is approx. 4-6 hours. The standby time is about 200 hours when
fully charged. The actual working time and standby time will depend on the type of mobile device, the
cellphone settings, and environmental conditions.
Note - Pairing with a smart Bluetooth-enabled device only needs to be done one time.