Advertisement
Tip: For the cleanest tone possible, set the Clean channel
Loudness maximum, and use the Clean gain to adjust the overall volume level. For the most
overdriven sound possible from the Clean channel, set the Clean gain to maximum and bring up
the Clean Loudness to the desired
Note: This control is more
effective with closed-back speaker cabinets, and even more exaggerated with larger enclosures
and certain speakers.
To turn off the amplifier, follow the same turn-on procedure in reverse – allowing the amp to idle
in Standby mode for about 30 seconds before powering off. While it is perfectly okay to turn the
amp off immediately, idling in standby before powering off lets the filter capacitors inside the
amp fully discharge. If turned off immediately, there will still be some sound as the filter caps
continue to discharge.
3
Advertisement
