Davey EcoMatic COMM500 Installation And Operating Instructions Manual page 83

Once a suitable location is selected, drill a 32mm diameter hole in the pipe.
Once a suitable location is selected, drill a 32mm diameter hole in the pipe.
Once a suitable location is selected, drill a 32mm diameter hole in the pipe.
Una vez seleccionada una ubicación adecuada, perfore un agujero de 32 mm de diámetro en la tubería.
Place the O-ring in the groove on the inside face of the top half of the pipe clamp.
Place the O-ring in the groove on the inside face of the top half of the pipe clamp.
Coloque la junta tórica en la ranura, en la cara interior de la mitad superior de la abrazadera de sujeción.
Place the O-ring in the groove on the inside face of the top half of the pipe clamp.
Place the top half of the pipe clamp onto the pipe ensuring that the hole in the pipe cla
El interruptor de flujo no debería montarse en la parte inferior de tuberías horizontales. the pipe.
Place the top half of the pipe clamp onto the pipe ensuring that the hole in the pipe cla
Place the top half of the pipe clamp onto the pipe ensuring that the hole in the pipe cla
the pipe.
the pipe.
83