Advertisement
Quick Links
CTM SD Card Installation Guide
This document explains how to replace the SD card in a
VENUE S6L Channel Touch Module (CTM).
What's Included
• (1) Channel Touch Module SD Card
Required Materials
• (1) Channel Touch Module
• (1) Suction cup, for removing an existing CTM (one is in-
cluded in replacement CTM packages)
• Thin-profile head long-nose pliers
• 2.5mm for M4 button head screws
• Hex Nut-Driver 7/32-inch or 5.5mm or other tools for M3 hex
nuts
• Foam pad or other soft material, for laying the CTM on during
the procedure (not included)
• Anti-static wrist band
Installing a CTM
Replacing the SD card in an S6L CTM consists of the following
steps:
• Removing the CTM
• Replacing the CTM SD Card
• Reinstalling the CTM
• Confirming Installation
If you will be installing the updated CTM into a different po-
sition or different S6L control surface, you must unclaim the
module before removing it. See the Channel Touch Module
Installation Guide and follow its instructions for unclaiming
a module (before removing it) and assigning it (after it is in-
stalled into a new bay or different S6L control surface.
© 2016 Avid Technology, Inc
Removing the CTM
To remove a CTM:
Put on your anti-static wrist band and configure it according to
1
its instructions.
Power off your S6L control surface, and disconnect any power
2
cables attached to it.
Place a foam pad or other soft material on top on the Channel
3
Knob Module just below the CTM.
Using a 2.5 mm hex wrench, remove the six mounting screws
4
that secure the CTM or the CTM fill panel to the control sur-
face.
Set the screws aside to use later when you reinstall the CTM.
An installed CTM's six mounting screws
Press the suction cup to the lower part of the surface of the
5
CTM so it adheres to the screen.
9329-65738-00 REV A
CTM SD Card Installation Guide 1
Advertisement
Summary of Contents for Avid Technology CTM
- Page 1 Using a 2.5 mm hex wrench, remove the six mounting screws • (1) Suction cup, for removing an existing CTM (one is in- that secure the CTM or the CTM fill panel to the control sur- cluded in replacement CTM packages) face.
- Page 2 Holding the suction cup with one hand and the CTM with the Replacing the CTM SD Card other hand, carefully pull the CTM away from the control sur- face and gently pull the suction cup outward to remove the Replacing the CTM SD card requires the following steps (de-...
- Page 3 Installing the New SD Card After removing the original SD card, install its replacement card. To remove the installed SD card: Orient the CTM as shown below, with the top of the CTM To install the new SD card: closest to you.
- Page 4 After replacing the SD card and back cover, reinstall the CTM. To install the new CTM: Place a foam pad on top of the CKM below the CTM bay. Place the CTM face-down on top of the foam pad, making sure the connectors face the back of the control surface.
Need help?
Do you have a question about the CTM and is the answer not in the manual?
Questions and answers