Advertisement
Maintenance Instruction
The maintenance tips and times given in this part are general informations. It is
suggested to the user to decide maintenance instructios himself depending on
environmental and usage conditions. Turnstile must have maintenance by
authorized service periodically. In case it is not possible to connect with an
authorized dealer, get into contact with manufacturer company and obtain
information on periodical maintenance. The following are the control periods of
the spare parts and the operations to be performed:
Turnstile Body
Dust is removed with a damp cloth. Chemicals adhering to the
surface are cleaned with Würth brand stainless cleaning spray. (1 -
4 weeks)
Connectors
The reason of the jerky operation of the turnstile is that the wrong
installation or the connection elements are weakened in time. The
fasteners must be checked and the damaged parts replaced . (6
Months)
Selenoid
Solenoid is observed to prevent any problems in the locking
system. Replacement of parts in case of problems in operation or
locking. (12 Months)
Hydraulic
The turnstile arm is rotated one turn to control the damper. If the
Damper
arm stops decelerating when completing the lap and there is no
impact, the damper setting is normal and operational. If the
rotation cannot be completed or multiplied, the damper setting is
checked first, if not, it is replaced with a new one. In addition, the
damper needs to be adjusted due to seasonal temperature
differences. The screw on the back of the d amper is placed in the
1.5-2 position in the summer, and in the 2-3 position in the winter,
allowing the turnstile arm to stop softly and without impact. If the
damper adjustment is not done well, the relevant mechanism parts
(lock paws, bobbins, etc.) will wear out more quickly. (12 months)
Connection
The solenoid and micro switches on the mechanism are visually
Cables
controlled. The tightness and connections of the Megaradar 10 -
position terminal screws are checked. (12 months)
Central Control
The mechanism is rotated one turn to see if it is working properly, rotating
Equipments and
parts (Central Control Element Tubes) and working surfaces. The
Rotation Parts
problematic parts are checked and replaced if necessary. If there is no
problem in operation, the tubes and working surfaces are lubricated with
WD40 spray and the maintenance is completed. (These parts are shipped
from production by lubricating with WD40 spray.) (12 months)
Electronic
The plugs (connectors) of the transition cards between the cards
Equipment and
and the cables from the cards to the turnstile assembly are
Cabling
checked. The turnstile works by observing the turnstile. If there is
no problem in the turnstile operation, the system is operational.
If a problem is observed in the study, problem cards are identified
and replaced with a new one. (12 months) Note: It is
recommended to use Würth brand oxide cleaner for cleaning.
System Operating
Validator and card reader system operation, operation, detailed
Control and
control and maintenance information can be found in the
Maintenance
validator and card reader document.
8
Advertisement
