Charging And Recharging - Loftek Nova Power Quick Start Manual

Function Details
The red light is always on when the clamp
is short-circuited, the buzzer sounds long,
Short Circuit
and the protection can be automatically
Protection
released after the fault is removed.
If the clamps are not connected to the
correct positive and negative terminals,
Reverse
the light will turn red and the buzzer keeps
Connection
beeping for a short time. The protection
Protection
can be automatically released after
troubleshooting.
The output is automatically disconnected
Reverse during reverse charge protection, and the
Charge traffic lights flash alternately. The
Protection protection can be automatically released
after the fault is removed.
If the clamps are connected to the start
Input Low /
port which is higher or lower voltage, the
High Voltage
protection function will be triggered and
Protection
the red light is always on.
The clamps will automatically be
disconnected when it is hot(≥80 ºC±10 ºC),
High
and the light will keep showing red; when
Temperature
the temperature of the clamp is lower
Protection
than 70 ºC, the protection is automatically
released.
07
How to use LED flashlight?
1.) Long press the function button for 3s to turn on the
constant light.
2.) Then short press the function button, shifting to the SOS
mode (Slow flickering).
3.) Short press again, shifting to Strobe mode (fast flickering).
4.) Long press the function button to turn off the light.

Charging and Recharging

1.) Charge your phone or other devices
2
1
2.) Recharge your jump starter
08