Page 1
Operators & Parts Manual GPN 235883 REV* 07/01/2021 COPYRIGHT Neither this manual or part thereof may be reproduced or published without the prior permission of AF Gason Pty Ltd...
Page 2
OH&S Compliance Certification Company Name A.F. GASON PTY LTD A hazard identification, risk assessment and risk control procedure has been carried out on a representative example of the under men- tioned product(s) in accordance with the Occupational Health and Safety requirements of all states and territories of Australia and where found necessary the appropriate risk control measures have been incorporated in the product specifications.
Contents Safety ..............................2 Installation .............................. 3 Torque Specifications ..........................3 Set-up ..............................4 Operation ..............................4 Maintenance ............................4 10 hours (Daily) ........................... 4 100 hours (Weekly)..........................4 Bush Replacement ..........................5 Tyre/Bearing Replacement ......................... 5 Spare Parts .............................. 6 Base Parts Assembly –...
Page 4
75 years. We operate through a local dealer support network that spans the coun- Prior to use, please ensure the manual has try. Gason would like to thank you for pur- been read and understood. chasing your Australian made tillage attach- ment, and trust that you will have many years of trouble free service.
Disclaimer Gason accepts no responsibility or liability for any losses, injuries or damages that may result from failing to observe these safety rules.
Installation Installation Torque Specifications The Parallelogram Presswheel has been de- signed to fit into a Gason HydraTILL tine. Caution: Torque values listed on the First, fully raise the implement. The assembly following page should be used as a guide is installed by pinning though the shank and only.
Operation Set-up Operation 1. Before making any adjustments to the Par- When working with your frame mounted allelogram Presswheels read and under- presswheels, follow all operating guidelines in stand the operating instructions for your the Implement manual and regularly check for: implement.
Operation failure occurs, follow the following instruc- Bush Replacement tions for replacement of the bearings or press- wheel tyre. For pivots using hardened steel pins and bushes, follow the procedure below: Disassembly instructions 1. Remove wheel/tyre assembly from the Removal and installation of the bush must be Parallelogram by removing the M16 axle done as follows: bolt.