Download Print this page

ENFORCER IPV-P188Q Manual

Poe (power over ethernet) surge protector

IPV-P188Q

PoE (Power over Ethernet) Surge Protector

Manual

 Helps prevent damage to sensitive networking equipment

 Intercepts repeated surges and spikes that could damage network

equipment

 Installs on a Cat5e/6 4-pair UTP cable with RJ45 jacks

 Power and signal line protection

 10/100 Base-T Cat5/5e compatible

 Support mid-span PoE and end-span PoE

 Complies with 802.3af and 802.3at for PoE

 Includes a 16" grounding wire for convenient connection to ground

Table of Contents

Need help?

Do you have a question about the IPV-P188Q and is the answer not in the manual?

Page 1 IPV-P188Q PoE (Power over Ethernet) Surge Protector Manual  Helps prevent damage to sensitive networking equipment  Intercepts repeated surges and spikes that could damage network equipment  Installs on a Cat5e/6 4-pair UTP cable with RJ45 jacks  Power and signal line protection ...
Page 2 ENFORCER PoE (Power over Ethernet) Surge Protector Introduction: The ENFORCER PoE (Power over Ethernet) Surge Protector is a passive device that helps protect sensitive networking equipment from power surges. The device can be deployed in new installations or added to existing ones.
Page 3 ENFORCER PoE (Power over Ethernet) Surge Protector Parts List: PoE Surge Protector Mounting Screws Plastic Wall Anchors Installation: NOTE: These instructions assume that 2 PoE devices have already been connected together. Protecting a Single Device: 1. The PoE Surge Protector should be mounted as close as possible to the device that is to be protected.
Page 4 ENFORCER PoE (Power over Ethernet) Surge Protector Troubleshooting: Wavy or ghost video image if connected to  Move the cable away from possible sources of interference. an image processor (e.g., multiplexer or  Replace the cable with a new cable.