Advertisement
Quick Links
Advertisement
Summary of Contents for JXD CPE-A311
- Page 1 CPE-A311...
- Page 2 Contents !.Product introduction 2.Work,ng diagram 3.Settings connection with internet by Ethernet 4.Settings of connection with internet by 3G/4G network WIFI connection and settings 6.WEB connection and settings 7.Fault judgement and Precautions...
- Page 3 1 2 3 4 5 6 7 8 910 1 1 215...
- Page 4 Icon Functions CPE connected with power supply, light is on under power-on status. Off: CPE disconnected with power supply, the indicator light is off After CPE starts indicator light is on if SIM card inserted . It will blink after registering on the network and 垂...
- Page 5 Upgrade software. SIM card Insert card, ,tis used for connecting with network. Support slot standa SIM card 「 To provide wired data t ansmission lo the LAN port terminal. 「 「 1s used for connecting a computer or other local area network interface equipment Dial up phone.
- Page 6 2).Power on CPE all indicator lights on panel on one time, later the power indicator light is WIFI indicator light is on, the device starts up completely 3). Connect the Ethernet cable to the ETH1 port the indicator light of ETH1 is on. Make sure the Ethernet can connect with network successfully...
- Page 7 Model No.: CPE-A311 Power Supply:12V/1A IP:192.168.100.1 Username/Password:admin WIFI KEY:1234567890 SN:A32020192800001 IMEI:358511043383151 WIFI KEY:1234567890...
- Page 8 Password Network Notifications Notify me when there is an open network nearby Show password network Protected through WPA / WPA2 Connect Settings Cancel Model No.: CPE-A311 Power Supply:12V/1A IP:192.168.100.1 Username/Password:admin WIFI KEY:1234567890 SN:A32020192800001 IMEI:358511043383151 Web IP:192.168.100.1 Username: admin Password: admin...
- Page 9 Judgement and Precautions Judgement:...
- Page 10 a. If the indicator light is on within 3 minutes which means the CPE is searching the network b. If the indicato light 1s on more than 3 minutes without blink ing 「 which means the base station network cannot be detected by the CPE please change the CPE placing position and retry Precautions...
-
Page 11: Fcc Statement
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference received, including interference that may cause undesired operation. any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Need help?
Do you have a question about the CPE-A311 and is the answer not in the manual?
Questions and answers