Table of Contents
Advertisement
Crest Healthcare Pro R:1
Supplemental Information
3. The block beside or under Tank Name (WASH/RINSE TANK or
RINSE/DRY TANK) displays current chosen cycle. Cycle 4 for
example.
4.
Alarm Display Area (duplication of #2).
Displays time remaining in current phase.
5.
6.
Displays how many Cycles can be processed with current system
water. When this display shows 0, Ultrasonic Cleaning System
completes a flush and drain of system.
DETERGENT and LUBRICANT LEVEL Line. Normally displays
7.
Detergent Level OK or Lubricant Level OK. Turns red and
displays either DETERGENT LEVEL LOW or LUBRICANT
LEVEL LOW.
Touch Pads:
8.
a. WASH/RINSE <START> – Press this touch pad to start Wash/
Rinse Phase of PJ Cycle.
WASH LID OPEN – Press this touch pad to open Wash
b.
Chamber lid. This touch pad is only active if cycle is paused
(see WASH/RINSE <PAUSE>).
WASH/RINSE <PAUSE> – Press this touch pad to pause
c.
Wash/Rinse Phase of PJ Cycle. Cycle must be paused to
open Wash Chamber Lid.
RINSE/DRY TANK – PJ W/R/D Units only, press this touch
d.
pad to toggle controls to Rinse/Dry tank functions.
DRYER LID OPEN – Press this touch pad to open Dry
e.
Chamber lid. This touch pad is only active if cycle is paused
(see RINSE/DRY <PAUSE>).
RINSE/DRY <START> – Press this touch pad to start Rinse/
f.
Dry Phase of PJ Cycle.
RINSE/DRY <PAUSE> – Press this touch pad to pause Rinse/
g.
Dry Phase of PJ Cycle. Cycle must be paused to open Dryer
Chamber Lid(PJ W/R/D only).
ALARM SILENCE/RESET – Press this touch pad when Control
h.
Panel ALARM: READ SCREEN Red Indicator lights. Control
resets alarm, resets indication and silences alarm buzzer.
WASH CYCLE SELECT – Press this touch pad to advance
i.
screen to CYCLE SELECTION (Wash/Rinse Tank) Screen
(see Figure 5-6).
DRY CYCLE SELECT – Press this touch pad to advance
j.
screen to CYCLE SELECTION (Rinse/Dry Tank) Screen.
MAIN1 – Press this touch pad to enable Cycle Parameters to
k.
be changed. For Supervisor/Service use only and Password
Protected. Enter password 783747. Control advances to
MAIN1 Screen (see
).
P
ARAMETERS
9. Displays PJ Cycle Phases (PRE-WASH, WASH, RINSE, FINAL
SPRAY or SPRAY RINSE). As Cycle progresses through phases,
display block changes from dark green to light green to indicate
which phase is active.
Operator Manual
S
5.3.4, C
ECTION
HANGING
C
YCLE
5-7
Advertisement
Table of Contents
