Section 6. Installation And Setup - Biostar P4VMA-M Description

Biostar p4vmam motherboard: supplementary guide

Hide thumbs Also See for P4VMA-M:

Table of Contents

ection 6.

In this section, you will learn how to install the CPU, DDR

Module, and also how to set up jumpers and all the information

about the components on the motherboard. Not only can you find

the installation steps, but also the details and locations of the

components on the motherboard.

1. CPU Installation

The motherboard supports the Intel Pentium

you are installing the CPU, make sure the CPU has a cooling fan attached on the right

to prevent overheating. If you do not find the cooling fan, contact your dealer and make

sure to install them before turning on the computer.

Step1: Pull the lever sideways away from the socket and then raise the

lever up to a 90-degree angle.

Step2: Look for the white dot/cut edge. The white dot/cut edge should

point towards the lever pivot. The CPU will fit only in the cor-

rect orientation.

Step3: Hold the CPU down firmly, and then close the lever.

Step4: Put the CPU fan on the CPU and buckle it. Connect the CPU fan

power cable to the JCFAN1. This completes the installation.

2 Central Processing Unit: CPU

These fan headers support cooling fans built in the computer. The fan wiring and

plug may be different according to the fan manufacturer. Connect the fan cable to the

connector while matching the black wire to the pin 1.

(1) CPU Fan Headers: JCFAN1

Installation and Setup

Socket-478 processor. When

Assignment

Ground

+12V

FAN RPM Rate Sense

11 11 11 11 11

English

Table of Contents

Show Quick Links

Table of Contents