Initial Operation; Mount Carrying Handle; Setting Up; Mains Connection - Grizzly GP 4645 Instructions For Use Manual

GB
30 mA; minimum fuse 10 am-
peres.
• Before each use, check the
equipment, cable and plug for
damage. Defective cables are
not to be repaired, but rather
replaced by new ones. Have
any damage to your equipment
repaired by a specialist.
• If the power cable for this
equipment is damaged, it must
be replaced by the manufac-
turer, a customer service agent
of the same or a similarly quali-
fied person in order to prevent
hazards.
• Do not pull the plug from the
socket by the cable. Protect
the cable from heat, oil and
sharp edges.
• Do not carry or fix the equip-
ment by the cable.
• Use only extension cables that
are protected from spray wa-
ter and designed for outdoor
use. Always fully unroll a cable
drum before use. Check the
cable for damage.
• Before any work on the equip-
ment, during work breaks and
in the case of non-use, remove
the plug from the socket.
• The cross-section of mains
connection lines must be no
smaller than rubber hose lines
with the designation H07RN-
F. The power cable wire cross
section must be at least 2.5
mm
2
18

Initial Operation

Mount carrying handle

Fix the carrying handle (7) to the
garden pump using the fixing
screws (8).

Setting up

• Place the unit on a firm, horizontal,
non-flooding surface.
• If you would like to install the device,
screw it together with the base. A
screw connection with a fastening
plate also prevents the device from
slipping.
By doing so, ensure a free access to
the drain screw (
• Always put up the garden pump at a
point higher than the water surface
you wish to pump water from.
Where this is impossible, install a low
pressure-resistant shut-off implement
between the appliance and the suc-
tion hose (available from specialist
retailers).

Mains Connection

The pump you have purchases is already
fitted with an earthed plug. The pump is
intended for connection to an earthed
socket at 230 V ~ 50 Hz.

Connecting the hoses

- On the suction side, attach a
hose with reflow stopper and
install a prefilter (available from
specialist retailers).
- On the suction side, do not use
any quick-action connection
systems.
10).