Advertisement
Quick Links
Assembly, Operation & Maintenance Instructions
NEO Beverage Cooler For
Built-In Module ECBIM17
NEO Outdoor Kitchen - For outdoor use only
IMPORTANT
PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE.
THIS IS IMPORTANT INFORMATION REGARDING THE
USE AND CARE OF YOUR BARBECUE.
September 2020
Assembly, Operation & Maintenence Instructions
Page 1
Advertisement
Related Manuals for Kettler NEO NBC208SS
Summary of Contents for Kettler NEO NBC208SS
- Page 1 Assembly, Operation & Maintenance Instructions NEO Beverage Cooler For Built-In Module ECBIM17 NEO Outdoor Kitchen - For outdoor use only IMPORTANT PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE. THIS IS IMPORTANT INFORMATION REGARDING THE USE AND CARE OF YOUR BARBECUE. September 2020 Assembly, Operation &...
-
Page 2: Table Of Contents
It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference. Due to continual product development, Kettler reserves the right to alter specifications or appearances without notice. Dispose of packaging responsibly – recycle where facilities are available. -
Page 3: Important Safety Instructions
Important Safety Instructions Important Read the assembly instruction section and safety precautions of this booklet carefully before removing the contents of this carton. 1. Do not store any foodstuffs in the beverage cooler 2. Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or service technician install an outlet near the appliance. -
Page 4: Installation
All electrical connections are to be made in a dry area. Outdoor power points must be weatherproof and installed by a qualified electrician. Kettler is not responsible for incorrectly located beverage coolers. Chose a location that is not too cold – the temperature should be above 10oC. -
Page 5: Operating Instructions
Operating Instructions Control Panel • Your beverage cooler has one control for regulating the temperature. The temperature control is located on the lower middle of the appliance. • If the unit is unplugged, loses power, or turned off; you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the beverage cooler will not start. -
Page 6: Care & Maintenance
Care and Maintenance Cleaning the Beverage Cooler Upon installation of your new appliance, it is recommended that it be cleaned thoroughly. Turn off the power to the appliance, unplug the beverage cooler and remove the trays. Wipe the inner and outer surface of the beverage cooler and its accessories with soft clean wet cloth. If they are too dirty, scrub them with neutral detergent, and then clean them with water and dry them with a clean cloth. -
Page 7: Data Labels With Electrical Diagrams
Data Labels & Electrical Diagrams Specifications are subject to change without prior notice. If the technical specifications are different from the data label on the back of the beverage cooler, please refer to the data label. Circuit Diagram Model NBC208SS Doors Capacity 208L... -
Page 8: Troubleshooting
Troubleshooting Problem Possible Cause Beverage cooler does not operate. Not plugged in. The circuit breaker tripped or a blown fuse. Compressor turns on and off The room temperature is hotter than normal. frequently. A large amount of beverages has been added into the beverage cooler. The door is open too often, or not fully closed. - Page 9 Assembly, Operation & Maintenence Instructions Page 9...
- Page 10 • Damaged components may endanger your safety or shorten the life of the product. Replace all damaged parts immediately. Use only spare parts manufactured by Kettler. Should you wish to purchase spare parts, they can be ordered directly from: www.kettler.co.uk/shop •...