CP Electronics DA-SL-PSU Product Manual

DA-SL-PSU
DALI SL Power Supply
Mount and wire the unit in the following method.
•
Remove terminal covers by unscrewing the clamp screws and inserting a small flat-bladed screwdriver into the
slots shown in the diagram below.
•
Affix the DA-SL-PSU using the fixing slots shown in the diagram below .
•
The fixing slots are suitable for M4 screws.
•
Wire unit using the screw terminals.
•
The screw terminals are suitable for solid core or stranded cable up to 2.5mm
•
Ensure that the main cable sheathing is over the cable clamp area. Clip on the terminal covers.
•
Insert the clamp screws and screw up until the cable is firmly clamped.
Release slots
Product Guide
The DA-SL-PSU is an SELV 16VDC power supply primarily
designed for DALI. The unit has an integral LED that is
visible through the front window to indicate that the output
voltage is healthy.
This unit can be used with the following systems and
products
•
•
•
Clamp screws
DALI lighting control systems.
®
An-10 AT-BB-IN wireless (RF) switch input unit
where latching switches are used.
Use in conjunction with
highbay detector head) to control standard DALI
drivers.
2
. Maximum cable OD 10mm.
Screw terminals
Fixing points

Overview

EBDHS-B32-SR-MP (SR

Installation

Cable clamp area

Wiring