Bg Radia Series R-400C Setup And Owners Manual page 11

Connecting Electronic Components and Hookup
1. If your home theater system has an integrated receiver, follow FIG.2 for
component connections.
2. If you use a separate preamplifier-processor and multi-channel power amplifier,
follow FIG.3 for suggested connections.
3. Use high quality 14 AWG loudspeaker wire for all loudspeaker connections.
Consult with your installer regarding what wire and cables will be best for your
system.
4. R-800 connections:
Connect woofers to BGA-2500 speaker outputs using loudspeaker cable
and two quick disconnect connectors (supplied) by stripping wires and
crimping them. The connectors are attached to the bottom woofer (The
tweeter array should be located on the outer side of the system).
Connect ribbon planar line array to your receiver/amplifier using two #10-24
hook connectors attached to PCB input terminals with #10 screws. These
Phillips Lug screws will be found on the back PCB (Printed Circuit board) of
the loudspeaker.
Crimp the wire and tighten the connectors with the screws.
#10 Phillips marked (+) on PCB to positive amplifier post
#10 Phillips marked (-) on PCB to negative amplifier post
5. R-400C connection:
Same as ribbon planar line array of R-800 (see above).
6. R-88Sub connection:
Same as R-800 woofer section (see above).
BG Corp 2005
Installation
11