Briggs & Stratton WaterSiren 6153 Installation And Operating Instructions

Description
The WaterSiren™ has a 90 decibel audible alarm that sounds
when water is detected and will chirp every 30 seconds if the
battery requires replacing. The WaterSiren can also connect to
the GenAlert Plus™ (B&S model 040206), to call up to three pre-
programmed phone numbers in the event of a water emergency.
Features
• Sounds an audible alarm of 90 decibels (at 10 ft / 3 m) if
water is detected.
• Alarm will sound and relay output is sustained up to
36 hours on a fresh 9 volt alkaline or lithium battery.
• Fully automatic operation and simple installation.
Battery Installation
To install the WaterSiren's required 9-volt battery, remove the
battery compartment cover on the back of the alarm. Install a
9-volt battery by connecting the top of the battery to the battery
clips in the compartment. Set the battery in the compartment and
close the cover. Be careful to not pinch any wires when replacing
the battery compartment cover and ensure the tabs snap into
place. Battery compartment keeps battery dry in up to 1/2"
(1.3cm) of water.
Replace the battery immediately after any alarm condition
or when you hear the alarm chirp, indicating a low battery.
Replace with a 9 volt alkaline or lithium battery. If device is fully
submerged, wipe unit dry and replace battery.
Positioning the Sensor
Place the water sensor on the floor near sump pumps, toilets,
sinks, washing machines, water heater, ice-makers or anywhere
water damage could occur.
The water sensor is located on the bottom of the WaterSiren.
It has two small metal pads that must both be touching water
to sound the siren. The water sensor may remain attached to
the WaterSiren (the whole unit is simply set on the floor) or the
water sensor may also be detached and placed within 6 feet
(1.8 M) of the WaterSiren in harder to reach areas.
WaterSiren™ Model 6153
Installation And Operating Instructions
Connecting the Auxiliary Alarm Output
The WaterSiren is connected to the GenAlert Plus by stripping
1/4" insulation off each end of 22 to 24-gauge wire two-
conductor wire (available as thermostat or doorbell wire). Attach
the 'NO' connection on the WaterSiren to the AUX ALARM
connection on the GenAlert Plus. Attach another stripped wire
Audible Alarm
from the 'COM' connection on the WaterSiren to the other AUX
ALARM connection on the GenAlert
Plus. These wires can be extended up
to 500 feet (152 m).
Use the tip of a pen or similar device
Alarm Output to push on the button and then push
wire end into the slot below the
button. When you remove the pen tip
pressure, the wire should be secure.
Specifications
Battery type: . . . . . . . . . . . . . . . . . . .9 volt alkaline (included)
Battery life: . . . . . . . . . Up to two years, depending upon use.
Audible alarm:. . . . . . . . . . . . . . . . . . . 90dB at 10 feet (3.0m)
Operating temp: . . . . . . . . . . . . . . . 32° to 120°F (0° to 49°C)
Storage temp: . . . . . . . . . . . . . . -20° to 150°F (-29° to 66°C)
Operating RH: . . . . . . . . . . . . . . . . 80% RH (non-condensing)
Water resistance: . . . . . . . . . . . . .Splash and water resistant.
Warranty
90 Day Limited Warranty
This is a "Limited Warranty" as defined in the U.S. Consumer Product Warranty
and Federal Trade Commission Improvement Act. This warranty gives you specific
legal rights, and you may also have other rights that vary from state to state or
country to country.
For a period of 90 days from the date of purchase, any malfunction caused by
factory defective parts or workmanship will be corrected at no charge to you.
To obtain a refund or a replacement, return the product to the place of purchase
along with proof of purchase.
Not Covered - Battery, repair service, adjustment and calibration due to misuse,
abuse or negligence and other expendable items are not covered by this
warranty. Unauthorized service or modification of the product or of any furnished
component will void this warranty in its entirety. This warranty does not include
reimbursement for inconvenience, installation, set-up time, loss of use or
unauthorized service.
This warranty covers only Briggs & Stratton WaterSiren products and is not
extended to premises, other equipment, and components that a consumer uses in
conjunction with our products.
SUCH REPAIR OR REPLACEMENT SHALL BE THE SOLE REMEDY OF THE
CUSTOMER AND THERE SHALL BE NO LIABILITY ON THE PART OF BRIGGS
& STRATTON POWER PRODUCTS GROUP, LLC FOR ANY SPECIAL, INDIRECT,
INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED
TO ANY LOSS OF BUSINESS OR PROFITS, WHETHER OR NOT FORESEEABLE.
Some states and countries do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you.
Press
Here
Wire
Briggs & Stratton Power Products Group, LLC
Jefferson, WI, USA
Slot