Wisniowski eL3V5Q Manual

Download this manual

eL3V5Q is a one channel radio receiver operating at a frequency of 433.92 MHz. Output relay can

operate in the monostable mode with adjustable activation time or bistable mode. The receiver is

compatible with transmitters with Keeloq dynamic code. The receiver can store up to 64 transmitters.

INSTALLATION

The first step of installation is to assemble the mechanical radio receiver, then to connect the output

and eL3V5Q supply voltage observing the wire colours as described on the enclosure. When instal-

lation and programming of transmitters is finished, put back the upper cover of the enclosure. The

device can be supplied with a voltage below 17V. In this case, solder the jumper "A" on fig. 1 before

assembly.

Important! Do not solder the live jumper!

When the memory is full or problems with transmitter programming appear, the memory should be

erased. To delete all the transmitters from the memory, press and hold the "SW" button on the con-

troller board until the LED starts blinking. Then release the button. Deleting lasts about 8 seconds. It

is recommended to begin with deleting procedure first after the receiver installation.

Programming is carried out by the button "SW". To program the transmitter, press shortly the "SW"

button (the LED will go out), and then release the button. Now you have about 10 seconds to press

the selected button on the transmitter.

If the programming has been done properly, the LED will flash 3 times. When the receiver memory

is full, the LED will flash only once, and then the controller will return to normal operation. If the

number of programmed transmitters is less than 64 and the LED informs about the full memory,

delete all transmitters from the memory and program the transmitters from the beginning. Repeat

the procedure to program all transmitters with the receiver.

fig. 1

IMPORTANT! With supply

voltage below 17V, solder

the jumper.

JUMPER

Radio receiver

eL3V5Q

OR/eL3QV5/ID-94199/KTM-653Y307941991/03/2016

Page 1 Radio receiver eL3V5Q eL3V5Q is a one channel radio receiver operating at a frequency of 433.92 MHz. Output relay can operate in the monostable mode with adjustable activation time or bistable mode. The receiver is compatible with transmitters with Keeloq dynamic code. The receiver can store up to 64 transmitters.
Page 2 Installation and Operating Instructions – Radio receiver eL3V5Q SELECTION OF OUTPUT MODE. Monostable mode with adjustable activation time. After receiving the signal from the transmitter, the output relay is activated for the time programmed by the user (1 s by default) and then returns to the previous mode. The output activation time is to be set up from 0.2 s to 7 s in increments of 0.2 s.