Brandstand Standroid Setup Instructions

Standroid
Setup Instructions
1. Assemble the bungie cord
poles by pushing the shafts
in the corded post.
5. Assemble waveline frame and place in front of Standroid make sure in middle.
After you assemble standroid ,lay horizantac and slide onefabric in position.
A B
A A
B B
7. Use the bolts supplied and attach to the TV as you can see in the above images.
Bolts(A) slide in to the hanging profile.Use wing nuts to secure TV profile.
2. Connect only one horizontal
on the first joint, see picture.
3. Lift the frame and fit to
the base, push it all the way
in to the round plate.
1
4. Force this last profile in
place and lock both sides,
it is made a little tight so it
locks the frame.
6. From the back insert the 2 bolts
that secure the TV profile. There
are 3 holes you can select the height
you need, push the fabric against the
screw and make a hole in the fabric.
8. After you connect the TV unit
you can cover the wires and the
connections by using the supplied
black fabric.