Product And Functions Power Switch LED Light Switch LED Light Connection Buckle Dust Cup Digital Display Pressure Gauge Inflator Air Valve Charging Interface PRESS Front PRESS PUSH Center PUSH DOWN STEP 2 STEP 1 Shut Down Mode Vaccum Cleaner Mode Tire Inflator Mode LED Mode...
Product Charge: Provides 2 modes of charging: It is in Charging Mode when the indicator light is red. It is fully charged when the indicator light changes to green. Reference: AC: Adapter: about 4.5h, USB: Charging: about 8h Attention: In order to prevent the machine from heating up and not gaining a full charge, Please allow the machine to cool for 15 minutes prior to charging.
Page 6
Disassembly & Cleaning 1. Use your finger to press the button in the direction of arrow 1, and use the other hand to rotate the dust cup out ( Figure 1) Figure 1 2. Take out the HEPA in the dust cup and install it in the direction of the arrow (Figure 2) Figure 2 3.
Instructions For Use (when used as an Tire Inflator) Inflation tube connection diagram Figure 5 How to use the digital display table: : Press once to turn on the LED display, Afterward, every press on the R can switch the unit between kg / m2, PSI, BAR, KPA : Decrease tire pressure : Increase tire pressure...
Precautions: 1.Before using the air pump for the first time, please read the manual carefully. Confirm all pieces are present and also check for any damage (switch, wires...) 2.Do not expose air pump to moisture, drops or sediment intrusion. The machine is not a toy and children should not operate unless under close supervision of an adult.
Troubleshooting Possible Reason Approach Low battery Charge the machine The motor does The machine continues not rotate to work for a long time, Naturally cool the machine for or stops during the internal hest, about 15 minutes before use inflation Start internal temperature portection program HEPA filter is covered with dust...