Advertisement
2. Filling Instructions
a. Fill battery with acid to upper level (a). Let battery stand for 60
minutes before charging. Gently move battery from side-to-side to
release any air bubbles between the plates. If acid level has fallen,
refill with acid to upper level.
NOTE: This will be the last time electrolyte (acid) should be added.
Return unused acid to the place where you purchased the battery
or neutralize acid with an equal amount of baking soda.
3. Charging Instructions
a. An initial charge is required before placing this battery into service.
For best results and maximum life, use a 500 mA Trickle Charger
(see chart for the proper charging time for your battery). To prevent
accidental release of acid during charging, place caps loosely over
access ports. Charge for the period of time indicated in the chart.
At the end of the charging time, the battery should gas freely.
Replace caps firmly, wash off any acid spillage with water and dry
battery.
b. Check the battery voltage after correct charging time and let stand
for 1-2 hours. Voltage should read 12.70 on a 12 volt battery of
6.35 on a 6 volt battery. If voltage is below specified voltage,
continue charging for an additional 40% of the total charging time
(example: 40% of 10 hrs. original charging time = 4 hrs. additional
charging time).
NOTE: If you have a 2 Amp or a 6 Amp charger, use the automatic
setting and charge until charger indicates complete charge or
battery gases freely. The voltage should read 12.70 V or 6.35 V.
Replace vent caps firmly, wash off any acid spillage with water and
dry battery.
c. After charging, attach clear vent tube. Be sure there are no bends
and that tube is free of blockage.
INSTRUCTION SHEET
Advertisement
